USB Micro-B connectors for USB 3.0 on a 1 TB external disk drive. Left-to-right are pins 10, 9, 8, 7, 6 in the left half, and 5, 4, 3, 2, 1 in the right half of each connector as seen here. Micro-B USB 3.0 Pinout ...
Below is the complete pinout table for the standard floppy drive 4-pin peripheral power connector (aka, Berg or Mini-Molex connector) as ofVersion 2.2 of the ATX Specification (PDF). test power supply voltages, be aware that the voltages must be within...
The Model 30 drives are 1.44MB, 34 pin with 5V and 12V on pins 3 and 6 of the ribbon cable respectively. People have successfully had goteks with the stock firmware running on these systems in place of the original drive, I am unfortunat...
Swap the cables and see if the problem moves between D1 and D2. Then send the small (and lower postage) bad drive in for repair. Or order a new cable. Bad disk controller card ? Get a new one, it's cheap, with only 8 TTLs, and throw the bad one away.Contrast that with the ...
–Connect the 5V to a 5V source. I just used the 5V coming from the FTDI cable. Note: The above picture shows you the actual pinout of the programming port, not where to plug the wires: Don’t forget to cross connect the TX and RX lines between the adapter and the usb drive (adap...