针对你遇到的问题“wpa_supplicant: /sbin/wpa_supplicant daemon failed to start”,这里有几个可能的解决方案和检查步骤,你可以按照以下步骤逐一排查: 检查wpa_supplicant服务状态: 你可以使用以下命令来检查wpa_supplicant服务的状态: bash systemctl status wpa_supplicant 这个命令会显示wpa_supplicant服务的当前状...
根据TheCW的b站视频和arch Linux的官方文档进行安装,没遇到太大的问题,有一些差别在于TheCW网络配置的127.0.0.1在官方文档中为127.0.1.1,我遵循了官方文档,然后iwctl我不会用,就使用了TheCW中的wpa_supplicant和dhcpcd命令。其中启动wpa_supplicant时好像遇到了Operation not possible due to rfkill问题,好像是因为网卡出现...
Solved Jump to solution Hi, We are using Intel Celeron 4205U + Intel 9560 2×2ac+BT HW running Ubuntu 18.04 system. When I enable hotspot, it works well but /var/log/syslog is filled with wpa_supplicant errors every second as below. And once disabled Hotspot, error will disappeare...
However, when I try to start a new monitoring interface, I get a "Device or resource busy (-16)" message: pi@rp3-ang:~/code/PwrDeauther $ sudo airmon-ng check kill Killing these processes: PID Name 323 wpa_supplicant 403 wpa_supplicant 422 wpa_supplicant 530 dhcpcd pi@rp3-ang:~/co...
3月02 08:10:03 www.dreamchasinger.cn systemd[1]: Configuration file /usr/lib/systemd/system/wpa_supplicant.service is marked executable. Please remove executable permission bits. Proceeding 3月02 08:10:07 www.dreamchasinger.cn systemd[1]: Configuration file /usr/lib/systemd/system/ebtables.se...
sio 4 年多前 in reply to S Prodigy 60 points Hi Saurabh As a result of continuing the investigation, we were able to solve the problem. You can now run the killallwpa_supplicant command to connect to the SSID before running ./sta_...
I had a similar problem;I try to start an ap scan by wpa_supplicant and wpa_cli;And stop it after get scan result, again and again; sometime I can see log like below(WILC Firmware Ver = WILC_WIFI_FW_REL_15_3_1 Build: 11736): ... wilc_sdio mmc0:0001:1 wlan0: INFO [wil...
- wpa_supplicant version: 2.9 - fmac driver: cypress-fmac-v4.14.77-2020_0115 - Firmware(brcmfmac43430-sdio.bin) version = wl0: Oct 22 2019 01:57:42 version 7.45.98.94 (r723000 CY) FWID 01-73a5ed62 - clm version: API: 12.2 / Data: LGHA.Voice / Compiler: 1.29.4 / ClmImport:...
│└─604 sshd: /usr/sbin/sshd -D [listener] 0 of 10-100 startups ├─avahi-daemon.service │├─342 avahi-daemon: running [raspberrypi.local] │└─362 avahi-daemon: chroot helper ├─wpa_supplicant.service │└─448 /sbin/wpa_supplicant -u -s -O /run/wpa_supplicant ├─triggerha...
The command you listed pumped out a lot of "failure resolving" and "failed to fetch" errors. Anything else I should try, or should I just burn it to the ground and try to start from scratch? Edit: I tried to send the bug report, but it refused to do that too. ...