1 loaded units listed. Pass --all to see loaded but inactive units, too. To show all installed unit files use 'systemctl list-unit-files'. [zsj@arch ~]$ sudo systemctl status systemd-modules-load.service ● systemd-modules-load.service - Load Kernel Modules Loaded: loaded (/usr/lib/sy...
See'systemctl status systemd-modules-load.service'fordetails. 如图: 按提示运行systemctl status systemd-modules-load.service,发现是ipmi_si设备不存在导致。错误提示如下: [ws@centos ~]$ systemctlstatussystemd-modules-load.service ● systemd-modules-load.service - Load Kernel Modules Loaded:loaded(/usr...
● systemd-modules-load.service - Load Kernel Modules Loaded: loaded (/usr/lib/systemd/system/systemd-modules-load.service; static) Active: active (exited) since Mon 2021-11-01 01:31:09 PDT; 5min ago Docs: man:systemd-modules-load.service(8) man:modules-load.d(5) Process: 642 ExecSt...
Re: "Failed to start load kernel modules" when booting Sat Aug 19, 2017 2:15 pm Hi, I just put a Pi-3 together and I see the same Failed message when Pi boots up. Below are the error and failed messages. I looked in both 'config.txt' and /etc/modules. I activated SPI, ssh ...
There was a recent change that might have broken our picking of the interpreter to run jupyter on reopen. That's likely what was causing the regression. We had found a good one before but we were unable to load that good one after you updated. ...
Details This seems to be a basic problem but I cannot figure-out why After I prepared every dependence, I use the following method to build: #!/bin/bash module load cmake fftw openmpi openblas elpa libxc scalapack PREFIX=/data/softwares/...
System does not boot with the followingXorg.logmessages after updating kernel. Raw [ 27.738] (EE) NVIDIA: Failed to initialize the NVIDIA kernel module. Please see the [ 27.738] (EE) NVIDIA: system's kernel log for additional error messages and [ 27.738] (EE) NVIDIA: consult the NVIDIA ...
Solved Jump to solution when i run a SGX remote attestation example (EPID attestation mode), it's failed: error: aesm_service returned error: 12error: load_enclave() failed with error -1 so i checked the aesm service with `service aesm service status` command, it is said: [load_qe ...
After the kernel vulnerability is fixed, you need to restart the server. If you do not restart the server, the vulnerability alarm still exists. The following failure causes only contain some key fields. For details, see the information displayed on theHSSconsole. ...
But if it is cBoot in Jetpack4.5.1, the serial will not interrupt the NX board to startup. Now I will first boot the NX board and then plug in the serial cable from Pixracer R15. It works!! Thank you very much!!system 关闭 2023 年4 月 12 日 01...