Board ESP32 s Device Description On Arduino UNO Hardware Configuration no Version v2.0.1 IDE Name Arduino Operating System Windows 10 Flash frequency 40 PSRAM enabled yes Upload speed 115200 Description Failed to connect to ESP32: No ser...
It's not clear to me whether all comments here refer to jupyter, but it is clear to me that everyone has the duplicate installed somewhere. 👍 1 Owner mhammond commented Nov 4, 2019 (and for completeness, an error on 3.8 where the error is that the DLL can not be found (as op...
you can connect it directly to ESP_EN (pin4 on EXTERN1). But if you use the TPS3809 (it has a push-pull output), I suggest a resistor in between the output of the
Then I had checked the wifi router , here I found that the IP which was assigned to the nodemcu v2 by wifi router, was bound to ARP Binding ( Address Resolution Protocol). I deleted the ARP Binding, and my nodemcu v2 had been started to work perfectly, it was connected to the MQTT ...
[Enter steps to reproduce:] ... ... Atom: 1.41.0 x64 Electron: 4.2.7 OS: Mac OS X 10.14.6 Thrown From: julia-client package 0.11.2 Stack Trace Failed to activate the julia-client package At Cannot find module '../build/Debug/pty.node' Er...