Airdrome Aeroplanes manufacturers two versions of this great little plane, one ultralight and experimental version. The ultralight version has smaller engine, a Rotax 377 (35 hp) vs the Rotax 503 (52 hp) for the experimental version. So if you choose to go with the experimental aircraft ...
The assay details, reproducibility (intra and inter assay variation) and accuracy of all these assays (recovery of added analyte) are described in detail on the websites of the manufacturers (interassay variability: 2–3%, intraassay variability: 2–4%, recovery: 93–116%) with the exception...
However, taking into account the nature of the controller (P&ID), the manufacturers adjusted the proportional constants so that the sensor response was immediate [20]. Additionally, studies such as the one carried out by Spanjers and Olsson show that making a first-order adjustment to the curve...
In recent years, the demand for Urban Air Mobility (UAM) and Micro Aerial Vehicles (MAVs) has driven the emergence of new aircraft designs, with the Staggered Rotor System being widely applied in these vertical take-off and landing aircraft. Due to the c
The derived 2-DOF model of the rolling-element bearing represents the operation of double-row self-aligning ball bearing (SABB) in the x-y plane. The specificity of the self-aligning ball bearing is referred to as its variable pressure angle (Figure 1). Moreover, in the studied bearing ...
The thermal conductivity and specific heat were determined utilizing a hot disk unit in combination with the measurement unit transient plane surface (TPS) 2500S (Hot Disk AB, Göteborg, Sweden). The CTE was experimentally calculated using the dynamic mechanical thermal analysis (DMTA) technique ...
Figure 14which shows the location of all sensors. The model frames were built in 2D which implies that they cannot resist out-of-plane shaking, so to avoid out-of-plane failure of the model frames, frictionless rollers were mounted against the out-of-plane support to avoid out-of-plane ...
Knowing the natural frequencies of different vibration modes and the boundary conditions, the elastic properties of the panel can be calculated, including the E in both major and minor axes and the in-plane shear modulus of the panel. Coppens [1] was one of the first using this method to ...