Full duplex : Enables sending and receiving of packets at the same time. This mode is used when the ethernet device is connected to a switch. Half duplex : Enables either sending or receiving of packets at a single point of time. This mode is used when the ethernet device is connected to...
Both devices of the Eth-Trunk must use the same number of physical interfaces, interface rate, duplex mode, and flow control mode. If an interface of the local device is added to an Eth-Trunk, an interface of the remote device directly connected to the interface of the local device must ...
4. Set the duplex mode. duplex { auto | full | half } Optional. The default setting is auto. 10-GE interfaces do not support this command. The switch does not support the duplex half command. 5. Set the transmission rate. speed { 10 | 100 | 1000 | auto } Optional. The default...
This example describes how to handle I2C data buffer transmission/reception between two boards, using an interrupt when the device is in Stop 2 mode. - - - - This example describes how to transfer data between two processors using IPCC Half-duplex channel mode. - - This example descr...
Run the display interface gigabitethernet 1/0/4 command in any view to check the working mode of the combo interface. [Switch] display interface gigabitethernet 1/0/4 ... Port Mode: FORCE COPPER Speed : 1000, Loopback: NONE Duplex: FULL, Negotiation: ENABLE Mdi : AUTO, Flow-control: ...
SPI SPI_HalfDuplex_ ComPollingIT This example shows how to ensure SPI data buffer transmission/reception between two boards by using Polling (LL Driver) an interrupt mode (HAL Driver). - - - - - - - - - X- - - - - - - - - - - - - - - - - - X- - - - - - - ...
· Half duplex/low speed The one at the top is chosen as the reference port. If two ports have the same aggregation priority, duplex mode, and speed, the one with the lower port number is chosen. Setting the aggregation state of each member port After choosing the reference port, the st...
Sets the maximum transmission unit value for Ethernet access. Two Interfaces with NAT - Advanced The configuration in provides an overview of how the various commands are used to create a configuration. This configuration shows the use of PAT (Port Address Translation), denying Java applets, using...
duplex full ! interface ATM4/0 no ip address load-interval 30 no atm sonet ilmi-keepalive no atm ilmi-keepalive ! interface ATM4/0.1 point-to-point ip address 10.10.10.2 255.255.255.0 pvc 40/40 vbr-nrt 155000 155000 1000 encapsulation aal5snap service-policy out...
The I2C is a multi-master, multi-slave, synchronous, bidirectional, half-duplex serial communication bus. It’s widely used for attaching lower-speed peripheral ICs to processors and microcontrollers in short-distance, intra-board communication. I2C Modes & Bus Speeds Originally, the I2C-bus was ...