They provide hardware management of the CTS and RTS signals, and RS485 Driver Enable. They are able to communicate at speeds of up to 17 Mbit/s. USART1, USART2, USART3, USART6, and USART10 also provide Smartcard mode (ISO 7816 compliant) and SPI-like communication capability. The USART...
EthernetRS-485RS-232 digital I/O module LM4I/4O-M 4-input impulse centralising equipment. Inputs are optoisolated to read impulses and it has a 32-bit memory to store the values metered. - It has an RS-485 communications port that can be used with an RS-232 or Ethernet converter ...
Pinout Diagram We recommend that you remove the jumper caps if you don't need to use the W5500 reset and interrupt functions, or pins 7, 8, 11 or 12 may not function properly. L: D13 digital pin level indicator TX: serial data transmitting indicator RX: serial data receiving indicator ...
1.1 Key Features Below are the key features of the expansion board: • Ethernet: – 4x 10/100/1000Mbps - RGMII ports (DP83867E) – 1x 10/100Mbps - RMII port (DP83822I) • 6x CAN interface • 6x LIN interface • PROFI BUS/RS485 port (DB9) • USS/IMU Sensor header •...
Pin 1TXD-Pin 2TXD+Pin 3RTS-Pin 4RTS+Pin 5GND Pin 6RXD-Pin 7RXD+Pin 8CTS Pin 9CTS+RS422/485 Pinout (9 Pin) Connector DB9 Connector - 9 Pin Male Power Input Power Over Ethernet OR 5 - 30V DC input, reverse polarity protected Power Consumption 1.74W LED Information Port Box Informa...
RTU and ASCII (tunneled via Modbus TCP) and Laurel ASCII. The latter is simpler than the Modbus protocol and is recom-mended when all devices are Laureates. Note that RS232 or RS485 data I/O in lieu of Ethernet is provided by our LT Series transmitters.• 4-20 mA, 0-20 mA or 0...
to 550 MHz, MPU, 1177 DMIPS/2.14 DMIPS/MHz (Dhrystone 2.1), and DSP instructions Memories • 1 Mbyte of embedded flash memory with ECC • SRAM: total 564 Kbytes all with ECC, including 128 Kbytes of data TCM RAM for critical real- time data + 432 Kbytes of system RAM (up to ...