root@hdl-hobc:~# dmesg | grep fec [ 3.369549] fec 30be0000.ethernet: 30be0000.ethernet supply phy not found, using dummy regulator [ 3.407414] fec 30be0000.ethernet (unnamed net_device) (uninitialized): Invalid MAC address: 00:00:00:00:00:00 [ 3.417545] fec 30be0000...
libphy: fec_enet_mii_bus: probedfec 20b4000.ethernet eth0: registered PHC device 02188000.ethernet supply phy not found, using dummy regulatorpps pps1: new PPS source ptp1fec 2188000.ethernet eth1: registered PHC device 1usbcore: registered new interface driver asixusbcore: registered new ...
[ 2.696014] am335x-phy-driver 47401b00.usb-phy: supply vcc not found, using dummy regulator Starting network: [ 6.665106] cpsw 4a100000.ethernet: initializing cpsw version 1.12 (0) [ 6.776572] cpsw 4a100000.ethernet: phy found:phy_id 0x7c0f1,on slave 0 [ 6.783302] SMSC LAN8710/...
[ 1.798495] TI TLK10X 10/100 Mbps PHY 4a101000.mdio:03: attached PHY driver [TI TLK10X 10/100 Mbps PHY] (mii_bus:phy_addr=4a101000.mdio:03, irq=POLL) [ 1.814407] IPv6: ADDRCONF(NETDEV_UP): eth1: link is not ready [ 3.768761] cpsw 4a100000.ethernet eth0...
[ 1.961752] mdio_bus stmmac-0:1f: attached PHY driver [unbound] (mii_bus:phy_addr=stmmac-0:1f, irq=POLL)[ 1.973049] dwc2 ffb40000.usb: supply vusb_d not found, using dummy regulator... [ OK ] Started Avahi mDNS/DNS-SD Stack.[ 9.542391] socfpga-dwmac ff700000.et...
Turn off the power supply (AC). Wait for 30 seconds. Turn on the power supply and boot to Windows*. Go to Device Manager. Find the I225 Controller. Uninstall all existing drivers. Install the latest LAN driver as provided in the download package. For official communication on this issue ...
Configuring WAN-PHY Error Thresholds Restrictions for LAN/WAN-PHY Mode Effective with Cisco IOS XE Release 3.18.1SP, A900-IMA8Z Interface Modules (IM) support LAN/WAN-PHY mode. The following A900-IMA8Z IM alarms are not supported: NEWPTR PSE ...
1 Intel is in the process of removing non-inclusive language from our current documentation, user interfaces, and code. Please note that retroactive changes are not always possible, and some non-inclusive language may remain in older documentation, user interfaces, and code.Company...
[ 0.689310] 001: mxs_phy 5b100000.usbphy: 5b100000.usbphy supply phy-3p0 not found, using dummy regulator [ 0.696636] 000: crng init done [ 0.703266] 001: regulator-usbh-vbus GPIO handle specifies active low - ignored [ 0.703805] 001: usb_phy_generic bus@5b000000:usb3-phy: bus@5b00...
Step 3: If the trouble is on all ports, the PoE section of the power supply can be defective if the switch works normally except for PoE and if non-PoE devices can establish a data ethernet link on any port. If the trouble is on a consecutive group of ports...