板子启动后进入根文件,在设置IP地址的时候 #ifconfig eth0 192.168.1.100 PHY 1:01 not found eth0: Could not attach to PHY stmmac_open: Cannot attach to PHY (error: -19) ifconfig: SIOCSIFFLAGS: No such device #ifcon
Hi All I used the latest PSP 4.00.01.13, EVM rev.F & VSDC rev.B, I found only eth0 could work correctly, eth1 doesn't, Does current PSP support two
_phy_generic.0.auto supply vcc not found, using dummy regulator [ 8.052169] dwmac-sun8i 1c30000.ethernet eth0: PHY [0.1:01] driver [Generic PHY] [ 8.053364] dwmac-sun8i 1c30000.ethernet eth0: No Safety Features support found [ 8.053380] dwmac-sun8i 1c30000.ethernet eth0: No MAC...
In: serialOut: serialErr: serialNet: phy init test2phy init test3ar8031 testphy reset 10Could not get PHY for emdio-3: addr 2 Warning: enetc-0 (eth0) using random MAC address - 22:66:ca:ba:0e:d6eth0: enetc-0 Then we found that there is no such phy in uboot:...
No working controllers foundHit any key to stop autoboot: 0switch to partitions #0, OKmmc0 is current deviceScanning mmc 0:1...Found U-Boot script /boot.scr292 bytes read in 7 ms (40 KiB/s)## Executing script at 419000004170472 bytes read in 194 ms (20.5 MiB/s)9041 bytes read ...
1.关于你要提交的问题 Q:是否搜索了issue (使用 "x" 选择) [x ] 没有类似的issue 2. 详细叙述 (1) 具体问题 A:eth0连接别的网口时,尽管网口灯是亮着的,但是在页面上看,显示半双工,没有协商成1000M。eth0作为WAN也无法正常使用 (2) 路由器型号和固件版本 A:h68k,线刷
"No valid Host_ID or host-name found." I then use YaST to set up the network. I get the following error message: "Unable to configure the network card because the kernel device is not present." The computer has Windows 7 installed ...
#lsmod no modules are enabled. #/etc/init.d/networking eth0 device eth0 not found failed ro bring up eth0. #ls /sys/class/net/ there is only lo but there is no eth0. 因此,这清楚地表明以太网驱动程序没有被启用。我有没有可能克服这个问 浏览0提问于2012-09-14得票数 0 2回答 获取...
found *** Warning - No MMC card found, using default environment In: serial@ff130000 Out: serial@ff130000 Err: serial@ff130000 Model: Xunlong Orange Pi R1 Plus LTS Net: eth0: ethernet@ff540000 Hit any key to stop autoboot: 0 MMC Device 0 not found no mmc device at slot 0 switch ...
Found APPUART 3.1.0 brd: module loaded loop: module loaded i.MX GPMI NFC NFC: Version 1, 8-chip GPMI and BCH Boot ROM: Version 1, Single-chip boot area, block mark swapping supported Scanning for NAND Flash chips... No NAND device found. gpmi-nfc gpmi-nfc.0: Chip scan failed mxs...