当拔出Hash模式为advanced的可扩展Eth-Trunk规格单板时,该单板Hash模式的配置信息会在系统中保留,用户可以通过undo eth-trunk load-balance hash-mode命令清除相应配置信息。 其它 若当前可扩展Eth-Trunk规格单板上存在接口与其他单板接口组成跨板Eth-Trunk,则当前可扩展Eth-Trunk规格单板不能更改Hash模式。如果要更改当...
Error: The interface XGigabitEthernet1/3/0/6 can not be added to the Eth-Trunk because the hash-mode of boards are different.无法加入成功。 解决方案 检查配置发现eth-trunk load-balance hash-mode advanced slot 1/3 通过eth-trunkload-balancehash-mode命令配置堆叠主备上对应槽位单板的Hash模式为一致...
(Optional) Run eth-trunk load-balance hash-mode { advanced | normal } slot slot-id A hash mode of the card is configured so that interfaces on the card can form an Eth-Trunk with interfaces on another card. (Optional) Add interfaces with different rates to the same Eth-Trunk. Run inte...
eth-trunk load-balance hash-mode advanced slot 8 assign trunk trunk-group 256 trunk-member 8 5– Reboot the switch 6– Insert the LPUs 1,2,3,4 After he inserted the LPUs 1,2,3,4 he got this error. "BASETRAP/4/ENTITYRESET:OID 1.3.6.1.4.1.2011.5.25.129.2.1.5 Physical entity is...
(Optional) Run eth-trunk load-balance hash-mode { advanced | normal } slot slot-id A hash mode of the card is configured so that interfaces on the card can form an Eth-Trunk with interfaces on another card. (Optional) Add interfaces with different rat...
eth-trunk load-balance hash-mode advanced slot 8 assign trunk trunk-group 256 trunk-member 8 5– Reboot the switch 6– Insert the LPUs 1,2,3,4 After he inserted the LPUs 1,2,3,4 he got this error. "BASETRAP/4/ENTITYRESET:OID 1.3.6.1.4.1.2011.5.25.129.2.1.5 Physical entity is ...
<HUAWEI>system-view[HUAWEI]interface eth-trunk1//创建Eth-Trunk接口 [HUAWEI-Eth-Trunk1]mode manual load-balance//配置Eth-Trunk的工作模式为手工模式 [HUAWEI-Eth-Trunk1]quit[HUAWEI]interface gigabitethernet 1/0/0//将接口加入到指定Eth-Trunk中 [HUAWEI-GigabitEthernet1/0/0]eth-trunk 1[HUAWEI-Gigab...
配置槽位号为1的X1E单板hash模式为advanced,以便增加eth-trunk成员端口数。 [HUAWEI] eth-trunk load-balance hash-mode advanced slot 1 配置设备支持的链路聚合组数目为64,每个链路聚合组支持的成员接口数目为16 [HUAWEI] assign trunk trunk-group 64 trunk-member 16 ...
然后检查两端设备上链路聚合的模式,没有发现异常 根据设备提示,查看eth-trunk接口的hash模式 发现两台设备槽位单板的hash模式不同,一台工作在advanced模式,一台工作在normal模式 解决方案 将两单板的hash模式修改一致(eth-trunk load-balance hash-mode),问题解决,业务测试正常...
You can run the load-balance command to configure an appropriate Eth-Trunk load balancing mode. This configuration ensures that outgoing traffic is properly load balanced among physical links, preventing congestion on these links. You can select a load balancing mode according to the actual ...