ADC1_CHANNEL_7 24.2.3原理图 ADC属于ESP32-S3内部资源,实际上我们只需要软件设置就可以正常工作,...
ADC_Init(ADC1, &ADC_InitStructure); // PA2对应的channel是 ADC_Channel_2 ADC_RegularChannelConfig(ADC1, ADC_Channel_2, 1, ADC_SampleTime_239Cycles5); // 启用ADC1的外部触发源 ADC_ExternalTrigConvCmd(ADC1, ENABLE); // 在 ADC1 上启用 DMA ADC_DMACmd(ADC1, ENABLE); ADC_Cmd(ADC1, ENA...
在读取ADC数据之前,必须先对ADC进行设置,然后才可以读出数据,设置的示例代码如下: //Configure ADC if (unit == ADC_UNIT_1) { adc1_config_width(ADC_WIDTH_BIT_12); adc1_config_channel_atten(channel, atten); } else { adc2_config_channel_atten((adc2_channel_t)channel, atten); } 1. 2. 3...
adc_dma_config.adc1_chan_mask |= BIT(channel2);adc_pattern[0] = { .atten = ADC_ATTEN_DB...
adc_dma_config.adc1_chan_mask |= BIT(channel2); adc_pattern[0] = { .atten = ADC_ATTEN_DB_11, .channel = channel1, .unit = ADC_UNIT_1, .bit_width = ADC_WIDTH_12Bit }; adc_pattern[1] = { .atten = ADC_ATTEN_DB_11, .channel = channel2, .unit = ADC_UNIT_1, .bit_wid...
–2 × 12 位 SAR ADC,多达 20 个通道 –1 × 温度传感器 –14 × 电容式传感 GPIO以下是 ESP32-S3 的关键特性: 1.Wi-Fi + Bluetooth 5 (LE) 无线连接 ESP32-S3 集成 2.4 GHz Wi-Fi (802.11 b/g/n) 功能,支持 40 MHz 带宽。其低功耗蓝牙子系统支持 Bluetooth 5 (LE) 和 Bluetooth Mesh,可...
信道选择(Channel Selection Algorithm #2) 硬件 模组接口:GPIO、SPI、LCD 接口、UART、I2C、I2S、Camera 接口、红 外遥控、脉冲计数器、LEDPWM、USB1.1 OTG、USB Serial/JTAG控制器、 MCPWM、SDIO 主机接口、GDMA、TWAI控制器(兼容 ISO 11898-1)、ADC、触摸传感器、温度传感器、定时器和看门狗 ...
Common wisdom on the Internet is to avoid attempting to use channel 2 ADC together with Wi-fi -- I couldn't even find any success reports. The battery examples in this repo are, suspiciously, running with wifi off, and the wifi example doesn't monitor the battery. Before I spend too ...
2,读取ADC原始数据 该函数用于读取ADC原始数据,其函数原型如下所示:int adc1_get_raw(adc1_channel...
.pattern_num = 2, }; adc_digi_pattern_config_t adc_pattern[2] = { { .atten = ADC_ATTEN, .bit_width = ADC_WIDTH, .channel = TEMP_INPUT_PIN, .unit = ADC_UNIT_1, }, { .atten = ADC_ATTEN, .bit_width = ADC_WIDTH,