Open the Serial Monitor with the baud rate : 115200. Press the ESP32-CAM on-board Reset button and wait for the IP to appear and wait for few seconds and then hit reset again. Step 8: Its Time to Check the Video Stream Open your browser and make sure your PC is connected to same ...
You can also override this logic and enable multiple clients for all transports (TCP, UDP, Multicast) by commenting out //#define OVERRIDE_RTSP_SINGLE_CLIENT_MODE in rtsp.cpp. However, enabling multiple clients for all transports can slow the stream down and may cause issues, so use with ...
RESULT = {"WC":{"Stream":1,"Resolution":8,"Mirror":0,"Flip":0,"Saturation":0,"Brightness":0,"Contrast":0,"SpecialEffect":0,"AWB":1,"WBMode":0,"AWBGain":1,"AEC":1,"AECValue":204,"AELevel":2,"AECDSP":1,"AGC":1,"AGCGain":5,"GainCeiling":0,"GammaCorrect":1,"LensCor...
Stream to NVR using integration to RTSPServer library contributed by @rjsachse. RTSP server now has multiple client support Frame resolution selection mismatch corrected due to #10801 in arduino core v3.1.0 SD card 4 bit mode configurable (see utilsFS.cpp) Shared I2C fixed following code ...