ryan4volts commented Jun 1, 2021 • edited The schematic for the variant shows the following pins should not be touched for flash reasons: IO6 IO7 IO8 IO9 IO10 IO11 Then these two must be pulled low to enter
The schematic says the LDO on that devboard is a SGM2212-3.3XKC3G/TR and the datasheet for that part says it can provide 800mA. The datasheet for the ESP32-S3 says you want to have at least 500mA reserved for that chip, leaving 300mA for anything else you want to feed from the...
How to configure GPIO 32 and 33 as input or output in ESP32 (IDFGH-1488)espressif/esp-idf#285 Closed mm108mentioned this issueAug 10, 2020 mrengineer7777mentioned this issueJun 16, 2023 WiFi and USB problem with CH9102 chip#8317
If they are correct, Do they need to appear in the schematic? Why are they necessary or can I take them off? Others like R14, C13, C14, and C15 have been removed from the board but not from the schematic, only then have been named as NC. Should I have to take care of them?
If they are correct, Do they need to appear in the schematic? Why are they necessary or can I take them off? Others like R14, C13, C14, and C15 have been removed from the board but not from the schematic, only then have been named as NC. Should I have to take care of them?