An error code returned by an API does not correspond to one error message. The following table lists only common error messages.Most ECS APIs are asynchronous. Some error
If this would be the case, and before you decide to fool around with registry hives, also check if your version of Windows 10 has S mode enabled. To disable S mode, refer to the steps described in the following link: https://support.microsoft....
Switch(config)#ip ssh client algorithm encryption ?3des-cbc Three-key 3DES in CBC modeaes128-cbc AES with 128-bit key in CBC modeaes128-ctr AES with 128-bit key in CTR modeaes192-cbc AES with 192-bit key in CBC modeaes192-ctr AES with 192-bit key in CTR modeaes256-cbc ...
If this would be the case, and before you decide to fool around with registry hives, also check if your version of Windows 10 has S mode enabled. To disable S mode, refer to the steps described in the following link: https://support.microsoft.com...
Switching from trial, you also need to align the editor configuration to the features available in your plan. If you already had one of our Cloud or Custom plans, please renew your license in the Customer Portal. license-key-invalid-distribution-channel Your license does not allow the ...
The interface is switched to Layer 3 mode. By default, an Ethernet interface works in Layer 2 mode. Only the S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6735-S, S6720-EI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support switching between Layer...
The interface is switched to Layer 3 mode. By default, an Ethernet interface works in Layer 2 mode. Only the S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6735-S, S6720-EI, S6720S-EI, S6730-H, S6730S-H, S6730-S, and S6730S-S support switching between Layer...
I try the workaround and the solution with the "power inline port 2x-mode" command on a 2960s POE+ 12.2 55(se5), but still the same problem. I also upgrade the firmware of the wireless controllers to the latest. Someone can help?
Switching to the yearly/monthly cluster is not allowed in this status. Scale-out or scale-in is not allowed for clusters that are not in the Running state. Wait until the cluster task is complete and the status changes to Running. 400 12000013 Failed to scale in the cluster (ID: xxx)....
[drm] *ERROR* [CRTC:98:pipe A] flip_done timed out This happens frequently (at least once every 5 minutes) but very irregular (sometimes twice in a minute, then not for 3-5 minutes) As it happens, the GUI freezes completely, but switching to a non-graphical Interface via Ctrl+Alt+...