but in this case put the initial egg near the eye of the hook. Make the first egg and let harden. Before you make another egg on the same hook you MUST get rid of all water that the HOT glue will come in contact with. The water will make the next egg bubble when the HOT...
* Sticky, like ‘Bubble Gum' - similar to a thick putty * Hard to mix and apply - knead the two parts together in hand-sized amounts and literally push on to the surface * Expensive on a ‘cost per square foot' - @ 1/4 thick and $50 gallon = $7.80 per square foot material co...
Inspection standard for the undercoat: Non-sticky to hand, no softening, no nail print if you scratch the surface. Top coat Mix JD-2000A and JD-2000 B based on 5:1 and then apply the mixture with spatula. The consumption quantity is 1.0kg/sqm. Maintenance 5-...
Inspection standard for the undercoat: Non-sticky to hand, no softening, no nail print if you scratch the surface. Top coat Mix JD-2000A and JD-2000 B based on 5:1 and then apply the mixture with spatula. The consumption quantity is 1.0kg/sqm. Maintenance 5-7 days. Don't put ...
1) You find that the resin is very sticky and gooey. This is probably a mixing error. It may be that the ratio (of resin to hardener) was incorrect or the two materials were not sufficiently mixed. This is a tough one to fix. You need to remove all uncured material from the surface...
By about 4:15 it was non-sticky but I could still make an indentation with my fingernail. By 6pm I couldn't do that anymore - it felt very hard. This is in contrast to the standard cure which in these temps is only workable for between 10 and 20 minutes after mixing and is hard...
1, room temperature (25 C) will be a gum and B glue to visual 1:1 ratio of overlapping coating or in a was sticky coating a glue, another stick coated part B glue and stick in together, before and after 2-3 times running after fixed for 5 minutes. 2, at room temperature (25 ...
In this paper, DSC curves at different heating rates were measured by DSC, the characteristic curing temperature was determined, and the optimum curing conditions were obtained. The KAS method, Friedman method and FWO method were used to analyze the DSC
Inspection standard for the undercoat: Non-sticky to hand, no softening, no nail print if you scratch the surface. Top coat Mix JD-2000A and JD-2000 B based on 5:1 and then apply the mixture with spatula. The consumption quantity is 1.0kg/sqm. Mainte...
Inspection standard for the undercoat: Non-sticky to hand, no softening, no nail print if you scratch the surface. Top coat Mix JD-2000A and JD-2000 B based on 5:1 and then apply the mixture with spatula. The consumption quantity is 1.0kg/sqm. Maintenance 5-7 days. Don't put...