continue; // 继续循环，或改为 cmd = 5; // 走一下default路径 }
A lot of software lets users enter numbers, then, on command, it converts those numbers into a graph. 很多软件都要求用户输入数字,然后在命令中将这些数字转换成为图形。 www.jukuu.com 5. Access infers the Number data type for the field when you enter numbers or paste numbers. Access会在您输入...
有几种方法可以使用 ENTER 键在编辑控件之间移动。 一种方法是在编辑控件和按钮的对话框中使用 WM_COMMAND 和附带的通知消息。 另一种方法涉及对编辑控件进行子类分类。 第三个涉及使用应用 Studio 和类向导,并创建新的对话框成员函数。 更多信息 方法I:(WM_COMMAND)...
If a dialog box or one of its controls currently has the input focus, then pressing the ENTER key causes Windows to send a WM_COMMAND message with the idItem (wParam) parameter set to the ID of the default command button. If the dialog box does not ha...
winrm create winrm/config/listener?Address=*+Transport=HTTP @{Port="\<port-number\>"} Don't use thePortparameter unless you must. The port setting in the command applies to all computers or sessions on which the command runs. An alternate port setting might prevent the command from running...
interface interface-type interface-number Configure interfaces not to enter the error-down state if the peer-link fails but the DAD status remains normal. m-lag unpaired-port reserved It is recommended that you configure this command on interfaces on both the M-LAG master and backup ...
与Invoke-Command(在将命令发送到远程计算机前会对其进行分析和解释)不同,Enter-PSSession不会对命令进行解释,而是直接将其发送到远程计算机。 如果你希望输入的会话正忙于处理命令,则在 PowerShell 响应Enter-PSSession命令之前可能有一段延迟。 一旦会话可用,你就会立即连接。 若要取消Enter-PSSession命令,请按CTRL+C...
5.1 使用lsblk命令 5.1 Using lsblk Command 打开终端。 输入以下命令并按下Enter:lsblk -o NAME,SERIAL 系统将显示所有硬盘及其序列号。 5.2 使用hdparm命令 5.2 Using hdparm Command 打开终端。 输入以下命令并按下Enter(需要root权限):sudo hdparm -I /dev/sda | grep 'Serial Number' ...
The command output displays the no-stack-link Error-Down alarm. Run the display error-down recovery command to check the interface Error-Down cause. <HUAWEI> display error-down recovery interface error-down cause recovery remainder time(sec) time(sec) --- 10GE1/4/0/0 no-stack-link -- -...
2. winrm create winrm/config/listener?Address=*+Transport=HTTP @{Port="<port-number>"} Do not use the Port parameter unless you must. The port setting in the command applies to all computers or sessions on which the command runs. An alternate port setting might prevent the command from ...