一、相关工具 模拟器:Cisco Packet Tracer Instructor 二、实验要求 使用模拟器配置交换机的enable、console和telnet密码,且密码都为ccna。 三、实验步骤 1、配置enable(特权模式)密码: a、首先安装好模拟器后,拖一个交换机和一台pc到界面上,并配置好console线...
Cisco 2900 路由器enable密码找回 1、重启路由器,60s内按下ctrl+break键,进入rom monitor模式,如果是笔记本电脑连在Console口上,另有的时候可能按 "ctrl+break"是无效的,还要和功能键配合才行 ,crtl+break也可以被屏蔽掉,这个时候先以1200,8,1,无,登陆,启动后,关机, 5秒后开机,同时按住空格键10-15秒,启动后...
Cisco 2900 路由器enable密码找回 1、重启路由器,60s内按下ctrl+break键,进入rom monitor模式: 2、rommon 1> confreg 0x2142 将Configuration Register Value 缺省设置为0x2142 3、rommon 2> reset 4、Router>enable Router#copy startupconfig runningconfig Router(config)#enable secret < password > Router(confi...
5 Specifies an ENCRYPTED secret will follow LINE The UNENCRYPTED (cleartext) 'enable' secret level Set exec level password Router(config)#enable secret 5 cisco Router(config)#exit Router# %SYS-5-CONFIG_I: Configured from console by console ...
设置路由器主机名 Router(config)#hostname test test(config)# 设置enable、console、aux、vty密码 enable密码(secret 密文保存,password 明文保存) test(config)#enable secret 123456 t
I'm wondering if this could also be achieved by using the enable secret password instead. I tried to figure that out on my own using Packet Tracer, but it doesn't look like I'm able to configure routers as an SCP server using PT. Thanks in advance!
cisco switch enable ssh and telnet 一、连接拓扑 PT3000 Boot Loader (PT3000-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1) Compiled Mon 22-Jul-02 18:57 by miwang Cisco WS-CSwitch-PT (RC32300) processor (revision C0) with 21039K bytes of memory. ...
cisco switch enable ssh and telnet 一、连接拓扑 PT3000 Boot Loader (PT3000-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1) Compiled Mon 22-Jul-02 18:57 by miwang Cisco WS-CSwitch-PT (RC32300) processor (revision C0) with 21039K bytes of memory. ...
I'm wondering if this could also be achieved by using the enable secret password instead. I tried to figure that out on my own using Packet Tracer, but it doesn't look like I'm able to configure routers as an SCP server using PT. Thanks in advance!
I'm wondering if this could also be achieved by using the enable secret password instead. I tried to figure that out on my own using Packet Tracer, but it doesn't look like I'm able to configure routers as an SCP server using PT. Thanks in advance!