1、配置登录密码 如果想成功登录到设备,必须在line线路下使用命令password来定义登录密码,否则无法成功登录(注:如果全局已经启用了相关认证如AAA,则在此不必配置密码) 注意:在此你配置的密码是保存在配置文件中的,即使你启用service password-encryption功能,它加密的方式也是一种可逆的加密,很容易破解,所以在使用过程中...
When Cisco inItially introduced encryption of the enable password it used MD5 encryption. (That is where the 5 in the enable secret command comes from). But over time issues developed and better forms of encryption were developed. And Cisco is advising that at some point use of MD5 encrypted...
Refer to Cisco Technical Tips Conventions for more information on document conventions. Access the Command-line Interface (CLI) on the Aironet AP You can use any of these methods in order to access the command-line interface (CLI) on the Aironet AP: The console port Telnet SSH If the...
I don't know how to confirm whether or not the firewall is enabled; this is part of the problem. The only device presently connected to the LAN interface is, in fact, a separate firewall (a non-Cisco product); there is nothing else beyond that firewall presently, as naturally we'd ...
Remotely when I run thecommand, certutil -config - -ping, my CA is not there in the list remove CA revoke all certificates - powershell or command line Remove EFS encryption from files that were inadvertantly encrypted so EFS can be turned off for entire domain without loosing access to...
LINE The UNENCRYPTED (cleartext) 'enable' secret level Set exec level password Router(config)#enable secret 5 cisco Router(config)#exit Router# %SYS-5-CONFIG_I: Configured from console by console exitPress RETURN to get started.Router>en Password: Password: Password: % Bad secretsCCNA...
cisco switch enable ssh and telnet 一、连接拓扑 PT3000 Boot Loader (PT3000-HBOOT-M) Version 12.1(11r)EA1, RELEASE SOFTWARE (fc1) Compiled Mon 22-Jul-02 18:57 by miwang Cisco WS-CSwitch-PT (RC32300) processor (revision C0) with 21039K bytes of memory. ...
Set the encryption key to<Encryption key of choice>. Choose the (time range)dayson which the issue is recreated/seen. 11. In order to collect the support bundle, click thedownloadbutton. Upload the support bundle and other details to the case fromhere. ...
Error - UNWILLING_TO_PERFORM - while change user password in AD ldap using python code Error "The encryption type requested is not supported by the KDC" when changing passwords on Accounts migrated with ADMT error (1256) the remote system is not availble Error <49>: ldap_simple_bind_s()...
The enable password isn't secured in the config. And even with the "enable password encrypt" command it can still be broken. Whereas the "enable secret" password is encrypted and can not be broken. See: http://www.cisco.com/warp/public/701/64.html Todd VanDerwerken...