The multicast ipv6 routing-enable command enables the IPv6 multicast routing function. The undo multicast ipv6 routing-enable command restores the default configuration. By default, the IPv6 multicast routing function is disabled. Format multicast ipv6 routing-enable undo multicast ipv6 routing-enable...
Theipv6 unicast-routingcommand globally enables IPv6 and must be the first IPv6 command executed on the router. The ipv6 address command assigns the prefix, the length, and the use of EUI-64 to assign the interface ID. Optionally, you can omit the eui-64 parameter and configure the entir...
IP Forwarding can be enabled (or disabled) from the Management Console by going into the Management Console > Configuration tab > Network > Routing > Gateways. IP Forwarding can be enabled (or disabled) through the CLI using the following command:...
PIM BFD (IPv6) depends on the BFD protocol. Therefore, you need first to enable BFD globally to validate the PIM BFD (IPv6) function. IPv6 multicast routing has been enabled using the multicast ipv6 routing-enable command in the system view. Before configuring PIM BFD (IPv6), enable PIM...
Run the ping command to access a client in the data center and check the connectivity. The result shows that the ECS instance in the VPC can access the client in the data center. Log on to the client in the data center. Run the ping command to access the ECS instance...
IPv6 routing disabled disabled IPv4 forwarding enabled enabled IPv6 forwarding disabled disabled Routing services "route:default ripng:default" If packet forwarding is enabled, turn it off Use either of the following commands: For therouteadmcommand, type the following: ...
Use the vi editor to open the/etc/sysctl.conffile, change the value ofnet.ipv4.ip_forwardto1, and enter:wqto save the change and exit. Run the following command to make the change take effect: sysctl -p /etc/sysctl.conf Configure the SNAT function. ...
echo 1 > /proc/sys/net/ipv4/ip_forward # Enable forwarding. This command takes effect temporarily and will be lost after a restart. Log on to ECS2 and install the mtr software, which is a diagnostic tool that merges the capabilities of ping and traceroute to analyze...
az network traffic-manager profile create \ --resource-group "[Sandbox resource group]" \ --name TM-MusicStream-Priority \ --routing-method Priority \ --unique-dns-name TM-MusicStream-Priority-$RANDOM You're using these parameters in the command: --routing-method Priority: Creates the Tr...
To enable IPv6 forwarding Open Command Prompt. At the command prompt, typenetsh, and then press ENTER. Typeinterface ipv6, and then press ENTER. Typeset interface[interface=]String[forwarding=]enabled Where: [interface=]String Specifies the interface name or index. ...