EN 485-1 Technical conditions for inspection and deliveryEN 485-2 Mechanical Properties EN 485-3 Tolerances for HOT Rolled MaterialEN 485-4 Tolerances for COLD Rolled materialEN 515 Temper Designations EN 573-1 Numerical alloy designation systemEN 573-2 Chemical symbol designation systemEN 573-3 ...
α2 represents the degree of rotation of the distal fracture block under rotational displacement relative to non-rotational displacement. α=|α1−α2| The degree of rotational displacement between the distal and proximal fracture blocks is designated by the symbol α. The degree of rotational dis...
Controller symbol "CPM". In CPM mode the following controller settings can be adjusted: • Speed • Range Of Motion • Synchronized Motion • Pause Time • Force • Lock Setting After the controller has been switched on and the Set key has been pressed, force is displayed on the ...
where the symbol \(\times\) denotes the cross product of vectors, and \({{\varvec{O}}}_{u}\) and \({{\varvec{O}}}_{r}\) are the origins of the ulna and the radius frames, respectively. The left hand side subscript t specifies that the landmarks are expressed in the thorax...
Open circle symbol indicates an outlier value ( > ± 1.5 IQR). ***indicates p < 0.001, * indicates p < 0.05 Full size image To determine possible retention effects of training on the right wrist, JND and MAE of all participants at retention were compared. With respect to...