The Y-axis controls the modulation amount. If you hold down the Alt (Win) / Option (Mac) modifier key while clicking in the X-Y field, the Y-axis controls the bandwidth. Note that bandwidth is not adjustable whe
If one or both of the contacting surfaces have a low compression modulus it is possible to make intimate contact between the surfaces which will lead to high friction forces in the case of plastics having good adhesion. It can add to the friction forces in another way. The displacement of ...
The effect of chemistry of the nanoparticle modifier group on the physical characteristics of the membranes is comparatively discussed. This study covers the correlation of the membrane characteristics with (i) the desalination performance data, (ii) the fouling data and (iii) the reliability data ...
At 2935 cm−1, methyl and methylene groups show stretch vibrations of C-H. The absorptions at 1116 cm−1 is a typical band for an ether group (which is specific for AHPS) and could verify the successful incorporation of AHPS into the tetrapolymer chain. There is no peak at 980...
very wide range of service temperature, such as good resistance to permanent deformation at high temperature and fatigue cracking at low temperature [7–9]. SBS modified asphalt is prepared by mixing the SBS modifier, pure asphalt and other small amount of additives under a certain temperature [...
In general, the low-φm metal oxides are used as a charge-injection interlayer (or modifier) in n-type OFETs (e.g., TiO2 [114], ZnO [115], [116], ZrO2 [117]), whereas high-φm metal oxides are applied to p-type OFETs (e.g., MoO3 [118], [119] WO3 [120], CuO [103]...
Generally, TiO2 acts both as the former and modifier in the glass network, which participates during the formation of the glass network in the form of [TiO4] or exists in the gap outside the network in the form of [TiO6] [8]. The addition of TiO2 in the glass-ceramics can improve ...
%. The result in this paper proved that the modifier can improve the properties of 7075 Al alloy. Keywords: 7075 Aluminum alloy; Sr modifier; mechanical properties 1. Introduction The insufficient mechanical properties of conventional steel drill pipes pose a challenge to the deep and ultra-deep ...
We confirm our former assumption in [5] that up to 10 mol %, ZnO enters as a modifier leading to a depolymerization of the network and to a less cross-linked network, as seen by an increase of the Q1 units at the expense of the expense of the Q2 units. This is in agreement with...
In the chemical method, considering the solubility and ease of treatment of the modifiers, the adsorption characteristics were derived according to the concentration, reaction speed, and temperature of the modifier in the organic solvent, while the degree of the coating and changes in surface ...