内容提示: ECSS‐E‐ST‐50‐12C 31 July 2008 65 8.5.2.3 ErrorWait a. The ErrorWait state shall be entered only from the ErrorReset state. b. In the ErrorWait state the receiver shall be enabled and the transmitter shall be reset. NOTE This allows the receiver to start the disconnection...
ECSS-E-ST-50-15C 系统标签: estecnoordwijsclaimercanopendecemberwarranty SpaceengineeringCANBusextensionprotocolForewordThisStandardisoneoftheseriesofECSSStandardsintendedtobeappliedtogetherforthemanagement,engineeringandproductassuranceinspaceprojectsandapplications.ECSSisacooperativeeffortoftheEuropeanSpaceAgency,nat...
compliant with ECSS-E-ST-50-52C • 8x SpaceWire ports, full duplex, on-chip or off- chip LVDS transceivers • 2x external FIFO ports, 9-bit wide data paths • Possible to cascade two routers without glue logic via the FIFO ports • 2x internal AMBA ports with DMA and RMAP •...
The initial frequency is specified [ECSS-E-ST-50-12C] to be 10 MHz. Once the auto link test has passed, the hardware can switch to the programmed rate. A local oscillator is used to supply the 10 MHz reference clock for initialization. A programmable PLL is used to support operation ...
The initial frequency is specified [ECSS-E-ST-50-12C] to be 10 MHz. Once the auto link test has passed, the hardware can switch to the programmed rate. A local oscillator is used to supply the 10 MHz reference clock for initialization. A programmable PLL is used to support operation ...
ECSS-Q-ST-70-56C-DFR1(23January2013).doc - European Cooperation on Dispositioned-DRRs_ECSS-Q-ST-70-71C-DIR1(Issue1-15April2014) ECSS-Q-ST-80C ECSS-Q-ST-70C Rev.1 -欧洲ECSS_Q_ST_60C标准解读 ECSS-E-ST-50-13C Draft D start...
SpaceWire features automatic link testing when a node is brought on line - released for operation via software. The transmitter sends NULLs until NULLs are received and then sends FCTs until FCTs are received. The initial frequency is specified [ECSS-E-ST-50-12C] to be 10 MHz. Once the aut...
SpaceWire features automatic link testing when a node is brought on line - released for operation via software. The transmitter sends NULLs until NULLs are received and then sends FCTs until FCTs are received. The initial frequency is specified [ECSS-E-ST-50-12C] to be 10 MHz. Once the aut...