The duty-cycled resistor is configured to connect the first resistor and the inverting terminal and to disconnect the first resistor and the reset voltage node during a first time interval included in a period to complete an on-and-off cycle of the duty-cycled resistor, and disconnect the ...
When switch 26 is closed, power from the output of protection circuitry 51 is supplied to the solenoid (not shown) during the on/off test via resistor R6 connected to jack 21. One side of resistor R6 is connected to switch 26 and the other side is connected to jack 21 and one side ...
Overload protection of duty-cycled load in housing. To protect duty-cycled loads without costly direct device temperature measurement, the load 1, e.g. a pump motor, is contained within a housing 2 and the temperature there sensed by PTG resistor 4.2. The circuit 4 adjusts load duty cycle...
At a load resistor of 100 kΩΩ, an output capacitor of 4 nF, and a carrier frequency of 144 MHz, the rectifier’s DC output voltage and PCE are increased by 300% (from 1.5 V to 6 V) and by 50% (from 14% to 64%), respectively, when the duty cycle ratio of the proposed ...
At a load resistor of 100 kΩΩ, an output capacitor of 4 nF, and a carrier frequency of 144 MHz, the rectifier’s DC output voltage and PCE are increased by 300% (from 1.5 V to 6 V) and by 50% (from 14% to 64%), respectively, when the duty cycle ratio of the proposed ...