The use of Schottky diodes make sure that load sharing occurs between the USB connectors on the LaunchPad kit and the BoosterPack module without any board modifications. The jumpers labeled J6 (1.8V) and J8 (3.3V) can be used to measure the total current consumption of the board from the...
Diese Liste der vom Anmelder aufgeführten Dokumente wurde automatisiert erzeugt und ist ausschließlich zur besseren Information des Lesers aufgenommen. Die Liste ist nicht Bestandteil der deutschen Patent- bzw. Gebrauchsmusteranmeldung. Das DPMA übernimmt keinerlei Haftung für etwaige Fehler...
The use of Schottky diodes make sure that load sharing occurs between the USB connectors on the LaunchPad kit and the BoosterPack module without any board modifications. The jumpers labeled J6 (1.8V) and J8 (3.3V) can be used to measure the total current consumption of the board from the...
M2-CC3351 Features • The mounted 0 Ohm resistor can be swapped to a different position to do conducted testing with the connector on board (J1/J2); the default configuration allows use of the onboard chip antenna (refer to Figure 2-1). Alternatively, there is footprint for an SMA ...
M2-CC3351 Features • The mounted 0 Ohm resistor can be swapped to a different position to do conducted testing with the connector on board (J1/J2); the default configuration allows use of the onboard chip antenna (refer to Figure 2-1). Alternatively, there is footprint for an SMA ...
M2-CC3351 Features • The mounted 0 Ohm resistor can be swapped to a different position to do conducted testing with the connector on board (J1/J2); the default configuration allows use of the onboard chip antenna (refer to Figure 2-1). Alternatively, there is footprint for an SMA ...