The pre-machined baulk (10A) is used to construct walls of all timber dwellings, and may have a uniform square cross section, being placed longitudinally one on top of another to form a wall. A tongue and groove system is utilised in the bed joints, two parallel longitudinal 'V' section...
The majority of interior doors can be supplied in sliding versions, both as single doors and pairs. The specificaitons of Double Leaf Wooden Sliding Barn Door, French Door: CONSTRUCTION General: tongue & groove construction with wood dowel connected between stiles and rails Species: red oak,...
4.The worktable can be tilted at 30 degrees for the processing of inclined tongue and groove. Product Parameters Working table lifter stroke 80mm Voltage 380V 50HZ 3PH The titled angle of working table ±20° Max. tenon chamfer width 120+2Rmm Max. tenin groove depth 60mm...
The tongue and groove run parallel to the edge (401) of the glass or panel. The lower edge of the groove (21) has a heel (213) which rests on the wooden frame. There are angle covers which cover the corners where two sections are joined together. 展开 ...
The profiles may be completely or partially of timber, metal, or concrete.DE10104168A1 * 2001年1月30日 2002年8月1日 Uti Holding & Man Ag Girder with double-T, U, or box profile for ceilings, double floors, etc. has tongue-and-groove connection system on upper and lower flanges and ...
Panelling (P) may be of the vertical tongue and grooved jointed board type, using nominal groove-bottom counter tongues to accommodate thermal and shrinkage effects. Certain boards may be in transparent plastic, all boards being nailed to continuous inset transverse rails located by morticing....
Panelling (P) may be of the vertical tongue and grooved jointed board type, using nominal groove-bottom counter tongues to accommodate thermal and shrinkage effects. Certain boards may be in transparent plastic, all boards being nailed to continuous inset transverse rails located by morticing....
The rails may be fixed by screwing to timber studs (10) which are in turn fixed to the wall (12), and may have an approximate 'L' section with a lateral 'T' section bar (16). Each flange (16A, 16B) of the 'T' may have a demi-arrowhead form which locates in a groove (24)...
The rails may be fixed by screwing to timber studs (10) which are in turn fixed to the wall (12), and may have an approximate 'L' section with a lateral 'T' section bar (16). Each flange (16A, 16B) of the 'T' may have a demi-arrowhead form which locates in a groove (24)...
The glazing unit is fixed inside an existing timber frame to effect double glazing, being equipped with hinges, fixing screw and seals. It uses a timber frame (1) with a groove (2) for a glass pane (V) bedded in mastic (3), its opposite side being rebated (7) to locate the flush...