My second monitor, some old Dell 1440p, running on displayport, ZERO issues and detected 100% of the time. Now, if I unplug my G7 DP at the monitor and plug it back in, it seems to work. That, or I have to restart the PC and hope it detects it. I have a very high end PC...
Please note, this monitor is specifically DisplayPort over USB-C (see: https://www.displayport.org/displayport-over-usb-c/) and not Lightning or a USB-C to DisplayPort adapter. After upgrading to Monterey, the monitor gets detected as an audio device, but no signal is displayed (black scre...
I get an occasional black screen with no signal detected on system boot. I've been following this issue on the Nvidia forums, and there are lots of complaints about it. I'm a little more fortunate in that I'm able to connect the monitor via HDMI which avoids the problem. But I'm...
No Boot Device Detected Very slow blinking 1/8 Hz (8s) Installation Completed Solid light SafeSlot Core+PCIe® 5.0 is 2x faster than PCIe® 4.0, so ASUS has adapted the SMT manufacturing process for the faster SafeSlot Core+, to ensure the highest data speeds. SafeSlot Core+ is a rei...
[Link Integrity Check] in '1A-01 Regular Procedure: With Receiver' are performed ¾ If a link integrity failure is detected within the initial two frames that are transmitted after encryption is re-enabled, then FAIL (Ref-1A-10) If a link integrity failure is not detected...
The DisplayPort Source DPCD registers 0x180 -> 0x1A0 for the Main Stream Attributes are used to set the values of the video being transmitted. These values should also match the video timing that is being input to the core on the User Data interface. These registers are not intended to be...
When corresponding DPCD register changes are detected via AUX monitor, this field will be updated. DisplayPort operating lane count • 0: 0 DP Lane • 1: 1 DP Lane • 2: 2 DP lanes • 3: 4 DP lanes This field may be modified thru I2C write or AUX monitor function. When ...
The event can occur if the video rate does not match the TU size programming. [0] - FIFO_OVERFLOW_FLAG: 1 indicates that the internal FIFO has detected an overflow condition. This bit clears upon read. INTERRUPT_SIGNAL_STATE. Contains the raw signal values for those conditions which might ...
The OS calls KMD's DXGKDDI_QUERYCONNECTIONCHANGE function whenever a connector status change is detected. When a DisplayPort monitor has been connected to a specified VidPn target and is connected to a USB4 DP-IN adapter, the driver should:...
DisplayPort Retimer 9 Initial Power-up Configuration www.ti.com 4.1 Reinitialize PLL, RX, and TX Settings The DP159 PLL, RX, and TX settings must be reinitialized anytime there is a change in datarate, lane count, HPD de-asserted (sink removal), or DisplayPort Source no longer detected....