It was also found that food wastes produce higher odour concentration per tonne of wastes. Finally, a mathematical model was developed relating specific odour concentration (odour concentration per tonne of wastes) to the ambient temperature. This model confirms that even in the worst conditions, ...
An economic assessment of thermal hydrolysis as a pretreatment to anaerobic digestion has been achieved to evaluate its implementation in full-scale plants. Six different solid wastes have been studied, among them municipal solid waste (MSW). Thermal hydrolysis has been tested with batch lab-scale ...
不同有机固体废弃物水解产酸特性研究 characteristics of hydrolysis and acidification of different organic solid wastes,不同有机固体废弃物水解产酸特性研究 characteristics of hydrolysis and acidification of different organic solid wastes,characteristics,of,hydrolysis,and,acidification,different,organic,solid,wastes...
摘要: This study was focused on co-composting of Cr(VI)-contaminated soil with three different biomass solid wastes for immobilizing Cr(VI).关键词: Co-composting Hexavalent chromium Biomass solid wastes Speciation Bioavailability DOI: 10.1007/s11368-017-1811-4 ...
Compression parameters of landfill municipal solid wastes sampled at different depths填埋场不同深度垃圾土压缩性的室内试验研究填埋场城市固体废弃物压缩指数孔隙比The compressibility of municipal solid waste(MSW) was described in this paper.Review was made on the compressibility in accordance with both ...
This paper investigates the drying and wetting water retention curves (WRCs) of municipal solid wastes (MSWs) with different paper contents, dry unit weights and degrees of biodegradation (DOBs). Fresh synthetic samples were prepared based on the field composition of the MSWs at Mugga Lane Landfi...
Currently in China, the biohazard levels of pathogenic microorganisms can be classified into four categories [ 7 ], with Category IV representing the lowest and Category I the highest level. Categories I and II are collectively referred to as highly pathogenic microorganisms. Microorganisms that are...
Considering all life cycle stages and multiple environmental impact categories enables comprehensive comparisons between options, showcasing their merits and trade-offs, highlighting areas for improvement and providing a robust framework to support decision-making. Several Authors have investigated the ...
fresh coniferous forest where pines are commonly planted in Tatynia forestry (Trzebież forestry district). It was assumed that, in case of positive results, further field studies should be conducted on the use of these previously unused “wastes” in forests, especially in fresh coniferous fores...
The objective of this work is to evaluate the reprocessing of PLA 3D printing waste from different origins, into filaments and films, and without the addition of any additive. Two types of waste were considered: a blend of different printing wastes (mask