TracepointDependentWarning TracepointDisabled TracepointEnabled TracepointError TracepointWarning TraceTransferInto TraceTransferOut TransactedReceiveScope TransactionalComponent TransactionNode TransactionScope TransferDatabaseObject TransferErrorMessage TransferJob TransferLogin TransferStoredProcedure Преобразов...
Procedure Issue a command of this form: # echo > /sys/devices/css0/chp0./status where: is a two digit hexadecimal CHPID. is either on or off. Examples • To set a CHPID 0x4a logically offline issue: # echo off > /sys/devices/css0/chp0.4a/status • To read the status ...
Procedure Issue a command of this form: # echo > /sys/devices/css0/chp0./status where: is a two digit hexadecimal CHPID. is either on or off. Examples • To set a CHPID 0x4a logically offline issue: # echo off > /sys/devices/css0/chp0.4a/status • To read the status ...
Procedure Rectifying the fault by referring to "Error Codes" in the IoT Device Access (IoTDA) References Check whether a specific error code is displayed when a command fails to be delivered. ● If yes, rectify the fault by referring to "Error Code Reference" in the IoT Device Access (...
The syntax for each VPN device configuration script is different and heavily dependent on the models and firmware versions. Pay special attention to your device model and version information against the available templates.Some parameter values must be unique on the device, and can't be determined ...
Procedure Step 1 Choose System > Health > Monitor. Step 2 Click the name of the device targeted by the FlexConfig policy. You might need to click the open/close arrow in the Count column in the Status table to see any devices. Step 3 Click View...
NI Device loader is dependent on the mDNS Responder Service in NI-DAQ™mx versions earlier than 9.6. If National Instruments mDNS Responder Service will not start, please contact NI Support. Additional InformationThis can happen when a computer's operating system takes a long time to boot. ...
On x86 platforms, use the eeprom command to make serial port A the console. This procedure is the same as the SPARC platform procedure. See Setting Up a Target System on the SPARC Platform. The eeprom command causes the console to switch to serial port A (COM1) during reboot....
inactive (timeout is inhibited) for some of the sequences on the I/O interface as described inCharacteristics of the I/O interface timeout function. With the timeout function inactive, the channel waits until the I/O device completes the tag sequence or initiates the next dependent sequence....
Procedure Issue a command of this form: # echo > /sys/devices/css0/chp0./status where: is a two digit hexadecimal CHPID. is either on or off. Examples • To set a CHPID 0x4a logically offline issue: # echo off > /sys/devices/css0/chp0.4a/status • To read the status ...