OS10 默认 VLAN 是 1 且默认所有 trunk 口都 untagged vlan1，如果需要修改其他 VLAN 为 默认 VLAN，参考如下：OS10# configure terminal OS10(config)# interface vlan 4093 OS10(conf-if-vl-4093)# exit OS10(config)# default vlan-id 4093 OS10(config)# do show vlan Codes: * - Def...
Default Setting(默认设置):该选项已启用 Master Password 此选项默认未启用 Lockout(主密码锁 定) 安全引导屏幕选项 选项 说明 Secure Boot Enable 该选项可启用或禁用安全引导功能. • Disabled(已禁用) • Enabled(已启用) 默认设置:Enabled(已启用) Intel 软件防护扩展屏幕选项 选项 Intel SGX Enable 说明 ...
OS10# configure terminal OS10(config)# interface port-channel 1 OS10(conf-if-po-1)# switchport mode trunk OS10(conf-if-po-1)# switchport trunk allowed vlan 10,20 OS10(conf-if-po-1)# no shutdown OS10(conf-if-po-1)# exit OS10(config)# interface range e1/1/49-1/1/50 OS10(...
共享 描述 This video will demonstrate upgrade procedure of OS10 Firmware From 10.5.1.7 to 10.5.2.4 Using a Dell Update Package for MX Switch CN/ZH 网站地图 账户 我的帐户 订单状态 个人资料设置 我的产品 支持 支持主页 ...
The following commands show how to configure this OOB port when using OS10EE. The switches start at their factory default settings as described in Appendix A.1. Note: The S5248F-ON CLI is accessible through the console port or by using SSH. The default username and password are both ...
OS10 image upgrade 525 Boot system partition526 Upgrade commands527 Chapter 8: OpenFlow 531 OpenFlow logical switch instance532 OpenFlow controller532 OpenFlow version 1.3532 Ports532 Flow table532 Group table533 Meter table 533 Instructions533 Action set533 Action types 534 Counters534 OpenFlow ...
This option is enabled by default. Allows you to determine whether changes to the setup options are allowed when an Administrator Password is set. If disabled the setup options are locked by the admin password. • Allow Wireless Switch Changes This option is not set by default. Allows you ...
Locks the system password. This option is set to Unlocked by default. NOTE: The TPM menu is available only when the TPM module is installed. Enables you to control the reporting mode of the TPM. The TPM Security option is set to Off by default. You can only modify the TPM Status, ...
Write down the IP network values in the space provided in the following table: Table 1: Configuration Information Item Value Fixed IP address (IPv4 or IPv6) for the switch (no DHCP server) Subnet mask Default gateway Brocade switch World Wide Name (WWN) located on the switch ID pull-out ...
• The S4112 is a 1RU, half-rack width 10/100GbE ToR switch with up to 12 ports of 10GbE (SFP+) or up to 12 ports of 10GBaseT ports, and up to three ports of 100GbE (QSFP28).• Multi-rate 100GbE ports support 10/25/40/50 GbE. 40GbE ports support 10GbE. 10GbE ...