delay () function delay()函数的工作方式非常简单。 它接受单个整数(或数字)参数。 该数字表示时间(以毫秒为单位)。 程序应该等到遇到此函数时转到下一行代码。 但问题是,delay()函数不是让程序等待的好方法,因为它被称为“阻塞”函数。 delay() function Syntax delay (ms) ; 其中,ms是暂停的时间(以毫秒为...
The Arduino delay function is an Extremely Useful function which you can use to get small delays. However, sometimes it's not the right function to use � there is another!
pin, without using the delay() function. This means that other code can run at the same time without being interrupted by the LED code. The circuit: * LED attached from pin 13 to ground. * Note: on most Arduinos, there is already an LED on the board that's attached to pin 13, s...
pin, without using the delay() function. This means that other code can run at the same time without being interrupted by the LED code. The circuit: * LED attached from pin 13 to ground. * Note: on most Arduinos, there is already an LED on the board that's attached to pin 13, s...
Arduino学习笔记---Blink without delay 上一篇里的 delay 非常拉,delay 的时候什么都不能做 这里把它规避掉 1/*2Blink without Delay34Turns on and off a light emitting diode (LED) connected to a digital pin,5without using the delay() function. This means that other code can run at the6same...
pin, without using the delay() function. This means that other code can run at the same time without being interrupted by the LED code. The circuit: * LED attached from pin 13 to ground. * Note: on most Arduinos, there is already an LED on the board ...
格瑞图:Arduino-0006-内置示例-亮度调节 Fade 格瑞图:Arduino-0007-内置示例-读取模拟电压 Read Analog Voltage 1、示例代码及解析 (1)代码 /*Blink without DelayTurns on and off a light emitting diode (LED) connected to a digital pin,without using the delay() function. This means that other code ...
I'm also willing to bet you used thedelay()function to define the intervals between the light turning on and off. But here's the thing: while delay is handy for basic demonstrations of how Arduino works, you really shouldn't be using it in the real world. Here's why – and what yo...
As you pointed out delay works fine in Arduino IDE, if you consider Arduino as component to be unsupported then please close this issue! Thanks @negativekelvin Jul 12, 2019 Wire()idf Is there a reason you don't want to set tick hz to 1000?
without using the delay() function. This means that other code can run at the same time without being interrupted by the LED code. The circuit: - Use the onboard LED. - Note: Most Arduinos have an on-board LED you can control. On the UNO, MEGA ...