default-route originate命令用来配置当前设备生成一条缺省路由或者将路由表中存在的缺省路由发送给邻居。 undo default-route originate命令用来恢复缺省情况。 缺省情况下,当前设备不向邻居发送缺省路由。 命令格式 default-route originate[costcost| {match default|route-policyroute-policy-name} [avoid-learning] ]*...
Defaultrouteoriginate是一种网络路由配置,用于指定默认路由器。默认路由器是指当目标网络地址不在路由表中时,数据包将被转发到此路由器。通过使用defaultroute originate命令,网络管理员可以在路由器上配置默认路由器。配置默认路由器可以简化网络配置,提高网络效率并确保连接到互联网。使用defaultroute originate命令配置默认...
default-route originate命令用来配置当前设备生成一条缺省路由或者将路由表中存在的缺省路由发送给邻居。und...
The default-route originate command configures RIP to originate a default route or advertise the default route in the routing table to neighbors. The undo default-route originate command restores the default configuration. By default, the device does not advertise the default route to neighbors. Fo...
在RIP中，因为没有默认路由的概念，而是通过 default-information originate 来模拟默认路由。它的作用是...
1. OSPF-缺省路由注入(default-route-advertise&default-route-advertise always)(5930) 2. BGP基础-BGP通告原则四则(277) 3. OSPF-智能计时器(lsa-arrival-interval & lsa-originate-interval)(248) 4. OSPD IP FRR(快速重路由)与BFD(双向转发检测机制)联动(228) 5. BGP基础-路径属性(185) Copyright...
R3 cannot originate a default route with the area 1 nssa default-information originate command only, to have an effect of this command we need to configure a static default route and the ASBR will originate an LSA Type 7 Default-route and this LSA 7 by definition has area-wide flooding sco...
default-information originateneighbor 10.1.3.3 remote-as 64512 address-family ipv4 unicast A route map with no match entry permits all routes. route-map PERMIT-ALL permit 10 In this example, Nexus receives the default route from EIGRP protocol. Therefore, the Nexus Routing Tab...
Additionally, to allow the default route to be installed from the source routing protocol in the BGP RIB, the commanddefault-information originateis required. Once in the BGP RIB, the default route is advertised to all BGP neighbors unless specifically denied by an outbou...
The ‘default-information originate’ command is required for OSPF to generate a default route. In our example above, router R1 is directly connected to the Internet. It’s a common enterprise setup where all Internet traffic breaks out from a single site. In R1, we have a static route ...