Nexus 5000 command "default interface x/x" Hello, when will be the command "default interface x/x" on the Nexus 5000 platform available? Even with latest software version (5.1.3.N2.1a) it is not possible. For N
To do the same on a CiscoASAyou need a different command, you use the ‘clear configure‘ command. Note: The interface naming used here is for an ASA8885-X the interfaces on your model may have a different naming standard, i.e. vlan1, ethernet1 etc.) Petes-ASA(config)#clear configur...
To set the date display format on all the Cisco IP phones attached to the router, use the date-format command in call-manager-fallback configuration mode. To display the date in default format, use the no form of this command. date-format {mm-dd-yy | dd-mm-yy} no date-format...
the interface in question has the command "no sysopt noproxyarp" configured on it. We are trying to understand how we can use a Flexconfig in FMC to change this behavior so that it does not proxy arp back to the host in question.. How can we change the behavior t...
command One of the SIP configuration commands. Valid choices are: bind : Configures the source address of signaling and media packets to a specific interface’s IP address. rel1xx : Enables all SIP provisional responses (other than 100 Trying) to be sent reliably to the remote SIP endpoi...
And i mentioned, that "ip proxy-arp" is enabled by default on any ip interface on Cisco IOS routers ... Expand Post LikeLikedUnlikeReply1 like Ing_Percy Edited by Admin February 16, 2020 at 5:03 AM Hi As the question is about the basic concept of Cisco Switches (CCNA), I limited ...
From the Cisco Press CCNA Portable Command Guide 2nd ed. Page 108 This example uses network address of 172.16.10.0 with a subnet mask of 255.255.255.0 and a router interface address of 172.16.10.1. 2960Switch>enable 2960Switch#config t ...
An IPv4 address is dynamically assigned to the connected node using the next available address from the DHCP pool. The node interface must be configured for DHCP to receive the address; most server nodes do so out-of-box, but router and switch nodes need specific configuration for this. ...
Cisco IOS中不存在`ip route-default`命令。默认路由的正确语法是`ip route 0.0.0.0 0.0.0.0 <下一跳IP>`,此选项语法错误。 2. **B.ip default-gateway 192.168.1.115** 正确。在二层交换机(L2 Switch)中,若未启用路由功能(如`ip routing`未开启),需使用`ip default-gateway`配置默认网关。 3. **C...
Command or syntax to configure a default route To configure an IPv4 default route, use the following syntax from the global configuration mode. Router(config)# ip route 0.0.0.0 0.0.0.0 {ip-address | exit-interface} To configure an IPv6 default route, use the following syntax from the global...