ip default-gateway 是cisco 里设置默认网关的命令，需要在全局模式下执行如：Switch(config)#ip default-gateway 10.0.0.254 此命令是将交换机的默认网关设置为10.0.0.254 2.路由器是不能执行此命令的，但在全局模式下执行no ip routing（关闭路由功能）后就可以执行。此时路由器是模拟一台主机，...
ip default-gateway 是Cisco网络配置中一个关键的命令，用于设定设备的默认网关地址。在全局配置模式下，如Switch(config)#下，可以输入 ip default-gateway 10.0.0.254 这样，交换机就会将10.0.0.254设为默认的网关，这对于跨网段通信极其重要，因为它提供了连接到其他网络的路径。然而，值得注意的是...
ip default-gateway 是cisco 里设置默认网关的命令，需要在全局模式下执行如：Switch(config)#ip default-gateway 10.0.0.254 此命令是将交换机的默认网关设置为10.0.0.254 2.路由器是不能执行此命令的，但在全局模式下执行no ip routing（关闭路由功能）后就可以执行。此时路由器是模拟一台主机，...
Since you are only using one vlan (vlan1) between the 3750 and the ISP gateway router, you don't need a trunk port, you just need an access port on fa2/0/1. Also, since the 3750 switch is just layer-2, all you need is a default-gateway. Your end devices gateway should ...
Cisco二层交换机的ip default-gateway的用途 Cisco的二层交换机上通常会有一个命令为ip default-gateway,直译就是默认网关的意思。 一直都知道在二层上面敲这个命令,但是对其概念和用途却不是很清楚。 网上有的朋友说这是和默认路由一个意思,今天经过一段研究,终于弄懂了其中的意思。
server1 is connected to switch1 and server2 is connected to switch2. server3 and server4 are on vlan2. server3 is connected to swtich1 and server4 is connected to switch2. server1 and server2 need to have the same default gateway and server3 and server4 have the same default...
I have some question about default gateway command: Which command set the default gateway to 192.168.12.1 on a Cisco switch: A. ip default-network 192.168.12.1 B. ip route-default 192.168.12.1 C. ip default-gateway 192.168.12.1 D. ip route 192.168.12.1 0.0.0.0 Now, I doubt about "A" ...
This chapter describes how to create the initial switch configuration (for example, assigning the switch IP address and default gateway information) for the Cisco CGS 2520 switch by using a variety of automatic and manual methods. It also describes how to modify the sw...
The "ip default-gateway x.y.z.w" command is necessary in a Layer 2 switch to management remotely. Without this command, you can't access by telnet/ssh On Cisco press Configure the Default Gateway. The switch should be configured with a default gateway if the switch will be mana...
The VXLAN border leaf switch can be a vPC or a NX-OS switch and the switch can be a TOR or an EOR. Similarly, the Classic Ethernet / FabricPath border-edge switch can be a vPC or a NX-OS switch. The ...