The DBL Ransomware is an encryption ransomware Trojan that is based on HiddenTear, an open source encryption ransomware platform that has been active since 2015, and has been the basis for countless Trojans of this type. The DBL Ransomware was first observed on February 9, 2019, and carries ...
PC clear or tinted Single-layer safety glass (SSG) clear Plastic windows made of PC heat-insulating Single-layer safety glass (SSG) heat-insulating Single-layer safety glass (SSG) for heat-insulating, tinted dark sliding roof Single-layer safety glass (SSG) for heat-insulating, tinted dark ...
−Change of scope: "New and not yet specified product versions and materials are specified using the applicable DBLs for virgins materials with the related requirements (e.g. DBL 5404, DBL 5416 etc.).“NOTE: This translation is for information purposes only.The German version shall prevail ...
Technical dataRequirements for product version CharacteristicsUnit00 PC 01 PPO 00 PP/EPDM 00 PP/EPDM T20 00 HCPP 3.1Density Tolerances g/cm1,19 + 0,02 1,06 + 0,02 0,90 + 0,02 1,04 + 0,02 0,90 + 0,01 3.2Residue on ignition (ash content) %? 5? 5?520 + 3,0 ?5 3.3...
version 2 Not for new designs 2 Normative references DBL 5404 Parts Manufactured from Thermoplastics for the Direct and Indirect Areas of the Passenger Compartment, for Passenger Compartment Heating and Venti- lation, Paneling and Housings DBL 5416 Parts Manufactured from Thermoplastics for Externally ...
ABS, PC/ABS DBL 5404 Spinning nozzle dyed textile fibers black or colored flock Polyamide Polyester Abbreviated designations:For drawings in the block for material e.g. Elastomer 70 ± 5 Shore A DBL 5571.10 in the block for design e.g. DBL 5575.20 and delivery 2.General proper...
DBL 5404.41 in the block for finish, e.g.:DBL 8465.10 on the drawing: PL/Cu25/Ni15d/Cr mc/mp Field of application, general requirements This DBL specifies the requirements for electroplated coatings on metallizable plastic parts. The coatings are intended to provide decorative component surfaces...
OpenPCDet Toolbox for LiDAR-based 3D Object Detection. - GitHub - briandbl/OpenPCDet: OpenPCDet Toolbox for LiDAR-based 3D Object Detection.
In case of ABS/PC blends, a material with 45 % polycarbonate content, undyed, should be used in preference for subsequent electroplating. In case of pre-structured surface, the surface structure shall conform to the specified reference samples. 1.2 Surface treatment The layer sequences shall be ...
Limit values for 1,3-butadiene: Material ABS* ABS PC/ABS PA/ABS GF material Unit mg/kg mg/kg mg/kg mg/kg mg/kg Specimen plate <1 <1 <1 <1 <5 Component <5 <3 <5 <5 < 15 Target value <1 <1 <1 <1 <5 *only valid for ABS of product version .51 (target value for ...