Glide When the pedal is pressed, the pitch changes, and then returns to normal pitch when the pedal is released. • Up/Down: Determines whether the pitch change goes up (is raised) or down (is lowered). • Range: Determines the range of the pitch change, in semitones. • On ...
Gain • Range: –12 — 0 — +12 (dB) If you change the value (even slightly) when any type except is selected, will be highlighted and the newly set value will overwrite the original setting. ON/OFF When equalizer setting values are contained in the song data or when EQ LOCK ON/...
— — VOICE SETTING VOICE SETTING VOICE SETTING PEDAL RANGE RIGHT — — — PEDAL PEDAL PEDAL ORGAN FLUTES ORGAN FLUTES VOICE JAZZ ORGAN — — VOICE SETTING VOICE SETTING VOICE SETTING (109/107/700) 1 FOOTAGE (16, 8, 5+1/3, 4, 2+2/3, 2, 1+1/3, 1) Depends on voice selection....
Usually the frequency range is150kHz to 30MHz, and a quasi-peak or average peak detector with a bandwidth of 9kHz is required to measure.The capacitive clamp can be opened and put in the cable to be measured. It is recommended to place the cable in the center as much as possible. The...
/// This function converts the specified invoek into a normall call. void changeToCall(InvokeInst *II, DomTreeUpdater *DTU = nullptr); +/// This function removes the default destination from the specified switch. +void createUnreachableSwitchDefault(SwitchInst *Switch, ...
shock. IMPORTANT NOTICE: All Yamaha electronic products are tested and approved by an independent safety testing laboratory in order that you may be sure that when it is properly installed and used in its normal and customary manner, all foreseeable risks have been eliminated. DO NOT modify this...
Parameter Display Min Max Table Control 1 Pedal Control 0 – 127 0 127 1 Type Normal, Low, Mid, High, 0 12 2 Bottom 0 – 127 0 127 Low/High, Low/Mid, Mid/ High, Full Bit, Wild, Attacky, 3 Top 0 – 127 0 127 Low End, Hard, Basic 4 Resonance Offset -12.0 – 0.0 ...
shock. IMPORTANT NOTICE: All Yamaha electronic products are tested and approved by an independent safety testing laboratory in order that you may be sure that when it is properly installed and used in its normal and customary manner, all foreseeable risks have been eliminated. DO NOT modify this...
• The functions of the Clavinova are set to certain standard values or standard conditions when the instrument is FUNCTION MIXER shipped. These settings and conditions are called the basic settings. • A function’s basic settings are gener- ally noted in the sidebar together with This ...
The LCD buttons can be pressed briefly to “sin- gle-step” the corresponding parameter, or held to scroll continuously through the parameter’s values. The panel [+]/ [–] buttons allow single- step operation only. – + 8 ○ ○○ ○ ○○ ○ ○ ○○ ○ ○○ ○ ○○ ○ ○○ ○...