Under union budget of India 2018–2019, INR 3762 crore (USD 581.09 million), was allotted for grid-interactive renewable power schemes and projects. As per the 31.12.2018, the installed capacity of total renewable power (excluding large hydropower) in the country amounted to 74.08166 GW. Around...
Government of India has signed a Financing Agreement for IDA Credit of USD 125 million (equivalent) for the “Skills Strengthening for Industrial Value Enhancement Operation (STRIVE) Project” with the World Bank. The Objective of the operation is to improve access to quality and market-driven ...
Total production cost was estimated at 28.55 INR/L, which is equivalent to 0.39 USD/L. These figures were based on the reflux method setup and foreseen to break even at 3.5 years [277]. Not only will economic sectors benefit but also the environment, waste management, and health of India...
The conversion gain exhibits a decrease of −0.13 µV/e−/◦C, and the gain of the PGA decreases at a rate of 0.0002 V/V/◦C. The nSFTSs exhibit a TC of 1.15 mV/◦C and an inaccuracy of ±0.55 ◦C. In order to prove the efficacy of this technique, two artificial ...
Other frequency current components are reduced at a very fast rate, so their reduction time can be ignored. After the high-frequency current decays to zero, the remaining component is the fundamental frequency current. This can be calculated based on the fundamental admittance. According to the ...
However, the learning time of the algorithm is altered because it needs to learn multiple harmonic components; this is a weakness [16,17]. By adding a learning rate in the updating algorithm, an improvement (Modified Widrow–Hoff (W-H) ADALINE) is made to the algorithm's extraction of ...
The aim is to improve the estimation of the transient DC voltage and current in the event of an AC line-to-ground fault. The proposed method consists primary of three interconnected modules for (a) equation conversion; (b) control-mode selection; and (c) DC-line modeling. Simulation case ...
2. HVDC Converter Technology Due to its inherent drawbacks, such as the inability to change voltage without trans- formers, the need for conversion equipment, the requirement for reactive power, harmon- ics, and the complexity of control, direct current transmission has only recently found ...
, attenuation rate in dissimilarity scenario is twice that of similarity. In a pipeline, attenuation is considered intrinsic when caused by absorption and extrinsic when caused by pipeline features like corrosions, cracks, and other defects that could decrease signal strength [90]. 2.4. Damage ...
Appl. Sci. 2019, 9, 1661 3 of 26 The superconducting fault limiter (SFCL) has attracted considerable attention because its nonlinear impedance characteristics can be used to limit the increase in fault current rate to provide a necessary time for relay protection. The SFCL can mainly be divided...