The particle size and elemental structure of copper nanoparticles were confirmed by XRD data and was found to be having a face-centered cubic structure.The resulting substituted imidazoles have been studied in the achievement of degree of drug absorption enhancement as well as the potential associated...
The silver and copper nanoparticles are often used due to their antibacterial and fungicidal activities, and this article presents the results of the nanoparticle synthesis using electrical glow discharge generated directly in a volume of their salt solutions. Therefore, there is no influence of air ...
Wang,C. H. Chang, et al.Microwave assisted synthesis of Cu2ZnSnS4colloidalnanoparticle inks.Physica Status Solidi A Applied Research. 2012B. Flynn, W. Wang, C. Chang, G.S. Herman, Microwave assisted synthesis of Cu2ZnSnS4 colloidal nanoparticle inks, Phys. Status Solidi A 209 (2012) ...
Wang, H.-W. Lee, Y. Deng, Z. Lu, P.-C. Hsu, Y. Liu, D. Lin, and Y. Cui, "Bifunctional non-noble metal oxide nanoparticle electrocatalysts through lithium-induced conversion for overall water splitting", Nature Communications 6, pp 7261 (2015) Chen, Y. Liu, Y. Li, J. Sun, Y...
Copper nanoparticle ensembles for selective electroreduction of CO2 to C2–C3 products. Proc. Natl Acad. Sci. USA 114, 10560–10565 (2017). CAS PubMed Google Scholar De Luna, P. et al. Catalyst electro-redeposition controls morphology and oxidation state for selective carbon dioxide reduction....
SYNTHESIS OF MULTINARY CHALCOGENIDE NANOPARTICLES COMPRISING Cu, Zn, Sn, S, AND SeNanoparticle compositions and methods for synthesizing multinary chalcogenide CZTSSe nanoparticles containing Cu, Zn, and Sn in combination with S, Se or both are described. The nanoparticles may be incorporated into one...
For copper oxide nanoparticle (CuO NP) production, 10 g of WPCB powder was leached for 3 h with NH4Cl (0.5–2.0 M) in 10% ammonia solution (S/L ratio 1/10). The solution was stirred constantly for 2 h and then left overnight. The formed CuO powder was centrifuged, washed with...
The minimum electrical resistivity of the sintered Cu nanoparticle film was 13 μΩ cm which was obtained after annealing at 300 °C. 展开 关键词: Experimental/ annealing copper deformation electrical resistivity metallic thin films nanofabrication nanoparticles pyrolysis shear strength sintering solders ...
Thus, the Ru nanoparticle perturbs the Cu substrate and weakens the Cu-H bond, allowing the binding energy to reach an optimal value for HER. In addition, we note that both Ru (Supplementary Table 3) and TiO2 spontaneously dissociate water, as also supported by EIS measurements (Supplementary...
Wang, H.-W. Lee, Y. Deng, Z. Lu, P.-C. Hsu, Y. Liu, D. Lin, and Y. Cui, "Bifunctional non-noble metal oxide nanoparticle electrocatalysts through lithium-induced conversion for overall water splitting", Nature Communications 6, pp 7261 (2015) ...