Before configuring a super-VLAN, you have configured sub-VLANs. Procedure Enter the system view. system-view Create a VLAN and enter the VLAN view. vlan vlan-id The value of vlan-id in this step must be different from the ID of a sub-VLAN. Create a super-VLAN. aggregate-vlan You ca...
A super-VLAN consists of one or more sub-VLANs. A VLANIF interface can be configured for the super-VLAN and assigned an IP address (no physical interface can be added to a super-VLAN). Before configuring a super-VLAN, ensure that sub-VLANs have been configured. Procedure Run system-vie...
10. Connect to ssh and run "swconfig dev switch0 show". It should show you three vlans like below (in my case, I assigned lan 3 and 4 to vlan3): VLAN1: ports 1 2 7t VLAN2: ports 0 7t VLAN3: ports 3 4 7t 11.I then started configuring the bridge. Start by creating a ...
Yes, I was using the 221.4 UI under the assumption of how 22.1.3 and older releases worked. I did this under the assumption that I could hit apply also only after configuring / enabling the VLAN interface in one go. Sometimes it's is actually helpful to be able to prepare configuration...
For best security, dedicate the Gigabit Ethernet adapter to vMotion, and use VLANs to divide the virtual machine and management traffic on the other adapter. For best availability, combine both adapters into a bond, and use VLANs to divide traffic into networks: one or more for virtual machi...
Creating multiple vLANs in a vRack 1824 2024-12-11 11:22:06 Cloud / Dedicated Server (bare metal) Configuring the vRack between the Public Cloud and a Dedicated Server 1073 2024-12-11 11:22:10 Cloud / Dedicated Server (bare metal) Setting up a Virtual Machine using Additional IPs...
This might involve setting up a static route or configuring the gateway's firewall to allow traffic from the new subnet. Verify that your phones are connecting to the correct network: Make sure that your phones are connecting to the new wifi network with the correct network name (SSID) and...
After adding and configuring the bonded interfaces, use the BondInterfaceOvsOptions parameter to set what directives each should use. You can find this in the parameters: section of /usr/share/openstack-tripleo-heat-templates/network/config/bond-with-vlans/ceph-storage.yaml....
This involves configuring BGP settings, ASNs, and VLANs. To add the Google Cloud connection in FortiManager 1. Collect the connection details from the Google console. Display the details of the connection you created in Google Cloud for this connection. Note the values for the Peer ASN, ...
2.4.2. Creating a Custom Role and Flavor for the Ceph MDS Service 2.4.3. Configuring Port Assignments for Custom Roles 2.5. Defining the Root Disk for Ceph Storage Nodes 2.6. Enabling Ceph Storage in the Overcloud 2.7. Mapping the Ceph Storage Node Disk Layout ...