I went through the basic setup of my DS220J but when I get to storage management I saw that a storage pool and volume already existed. I reset the entire NAS and did the process again but the same thing happened. Do DS220J's do automatically setup a SHR because they are for basic ...
I struggled with creating the storage pool. When the storage pool creation start, the web interface shows 'please wait' then the web interface goes down. I have to remove the virtual disk directly from ESXI, then I can refresh the page and the Synology is again available. WTF, it was ...
selected SHR and received this message 'System failed to create Storage Pool 2 with one or more drives (Drive 1, Drive 2). Please try again.' Then it started what is showing in the screenshot below, without Vol 2. This task started an hour ago, it is estimated to end in 10 more ...
I'm also using Synology'sHyper Backupto back up other shares to Amazon Drive. Amazon Drive allows for unlimited storage use, so I'm able to keep a bunch of revisions. In fact, I'm backing up the Dropbox and Google Drive data to Amazon Drive, so that in case something happens wit...
exporting hyper-v vm to a synology diskstation Exporting results from an if-else block to csv in powershell Exporting servers ILO health summary exporting to filename with timestamp part of filename Extend disk automatically with powershell 4 - self-service Extended Ascii characters showing as que...
I stumbled onto this thread, but I was looking for something related to Synology as I'm experiencing the same isssue. I eventually did it via the cli, but as I'm running a pool with multiple hosts I had to modify the above command: xe sr-create type=nfs device-config:server=(your ...
My old Synology NAS for home use had started to show signs of wear and was in need of replacement. It had plenty of disk space and performed well enough - but the version I had lacked any real power or cloud connectivity. I decided it was time to repurpose one...
exporting hyper-v vm to a synology diskstation Exporting results from an if-else block to csv in powershell Exporting servers ILO health summary exporting to filename with timestamp part of filename Extend disk automatically with powershell 4 - self-service Extended Ascii characters showing as que...
Created one maxed out storage pool and maxed out volume with the recommended btrfs file system. System is 'Healthy'. I haven't put any personal data on the NAS yet. ProblemWhen I try to create users with the wizard and go through all the steps, the second I press 'Done', I am ...
It automatically created a storage pool, filling up the maximum available space (2.7TB SHR) It also created a volume in this pool, of 800MB. I go to the Volume tab to create a new volume, but the "Create" button is greyed out. I can't see any reason why it should be. Any ideas...