解释jlink info: reset: halt core after reset via demcr.vc_corereset的含义: 这条信息来自于使用SEGGER J-Link调试器时,特别是在执行复位操作时出现的日志或信息提示。它表明在通过J-Link对目标设备进行复位操作后,使用了调试异常和监测控制寄存器(DEMCR)中的vc_corereset位来使核心(CPU)在复位后立即暂停(halt...
Why are we getting JLink Info: Reset: Halt core after reset via DEMCR.VC_CORERESET andJLink Info: Reset: Reset device via AIRCR.SYSRESETREQ? I have seen some other posts mentioning these two, but it is usually complicated with something else or not clearly answered. Thanks ...
* JLink Info: Reset: Halt core after reset via DEMCR.VC_CORERESET.* JLink Info: Reset: Reset...
- Reset: Halt core after reset via DEMCR.VC_CORERESET. - Reset: Reset device via AIRCR.SYSRESETREQ. - Executing init sequence ... - Initialized successfully - Target interface speed: 4000 kHz (Fixed) - WARNING: Unexpected core ID. (Found: 0x1993D01D, Expected: 0x4BA00477, Mask: 0x0...
monitor reset halt monitor reset init Then go to the“Common”tab and check“Debug”and“Run”in the“Display in favorites menu”. Finally, click on“Apply”and“Close”. 3.3 Launching a debug session Launch the debug session from the“Debug”or“Run”button in the toolbar. ...
Did your software get loaded into the right place? That is, if the CPU is coming out of reset properly, and if it is reading from the right addresses, is it getting the right values? If not, then this is worth chasing down through theVCD trace. You might find that you haven’t loa...
System Low Power (LP) mode is the default operating mode of the device after reset. It provides the maximum performance. While in System LP mode, the CPUs may operate in any of the Arm®-defined modes. System Ultra Low Power (ULP) mode is identical to LP mode with a performance trade...
The debug exception handler should check that the exception did not occur in V86 mode before continuing. If the exception did occur in V86 mode, the exception may be directed to the general-protection exception handler. Status: For the steppings affected, see the Summa...
17. The system of claim 16, wherein the trace unit further includes: a sixth logic to include, in the code execution stop packet, an indication of an instruction pointer address of a processor instruction that did not complete when the code execution stop packet was generated; and a seventh...
multifail 404 The requested file could not be found on the server. proxynotauth 407 The request requires a user ID and password for the proxy. Either the user ID and password sent by the client are not valid for this request or the client did not send a user ID and password. proxynot...