1. 连接Console线:将Console线的一端连接至计算机的USB口或蓝牙,另一端连接至网络设备的Console口。 2. 配置终端仿真程序:打开计算机上的终端仿真程序,如SecureCRT、PuTTY等,选择串口连接方式,设置串口号、波特率等参数。 3. 进入网络设备配置模式:在终端仿真程序中输入设备...
Connect the DB9 connector of the prepared console cable to the PC's serial port (COM), and the RJ45 connector to the device's console port. If there is no DB9 serial port on your terminal (PC), use a DB9-to-USB cable to connect the USB port to the terminal. Start PuTTY on the ...
Install a terminal emulation program, such as PuTTY, on the PC. Prepare a console configuration cable. If a third-party USB-to-RJ45 serial cable is used, it is recommended that the cable length be less than or equal to 2 m to ensure signal integrity. Establishing a Physical Connection Log...
This can be a direct RJ45-to-USB serial adapter or a standard USB-to-serial adapter and an RJ45-to-DB9 adapter or cable. It is also possible to utilize client hardware serial ports and compatible cables, but these ports are rare on modern hardware....
The main types of console cables are RJ45 to DB9 (a serial connector), USB Mini-B to USB-A, RJ45 to USB-A, and RJ45 to USB-C. These are quite different cable types that have been used for different eras of Cisco networking devices. They each have their places, though, and some of...
So from my point of view you have following options to connect to the device: Use a console cable (blue) with either RJ45 / Serial connectors or a RJ45 / RJ45 rollover with Adapter. Both require a serial port on the notebook or a USB to serial Adapter. Some devices allow...
Step 1. Connect your computer to the switch. If your computer has a serial port (COM), please connect it to the console port (RJ45) of the switch, with the RJ45 console cable. If you only have USB ports on your computer, you can get a USB-to-RS232 cable. You may need to instal...
通过以太网转USB线及console口连接网络设备 将USB转接线接到电脑时会提示找到新设备,此时需要安装对应驱动,可以连接店家获取驱动下载地址,我的线是JD上胜为买的,给了下载地址下载安装完成,可见设备驱动已加载注意,此处获取到的端口是6打开putty尝试连接 转接线 ...
通过以太网转USB线及console口连接网络设备 将USB转接线接到电脑时会提示找到新设备,此时需要安装对应驱动,可以连接店家获取驱动下载地址,我的线是JD上胜为买的,给了下载地址下载安装完成,可见设备驱动已加载注意,此处获取到的端口是6打开putty尝试连接 转接线 ...
It is a light blue USB to RJ45 cable and as previously stated works both on the AUX port of the ASR and other Cisco devices. I was able to go from an ASA which worked to the ASR which did not work then back where it did work again. I don’t believe the cable is bad in that...