To get started I created a small test circuit with just the interrupter. This allowed me to experiment and make sure things worked before I added it to the camera controller. Difficult to tell from the above photo but the red LED is on. Below, with the beam broken the LED goes out. S...
Connect the ground pin of Arduino with the ground pin of relay module, VCC pin on relay module with 5V on Arduino and finally pin 7 in Arduino with ln1 on relay module. Step 3 Upload the code given below to Arduino and switch on the current supply of the bulb through the ...
consists of the actuator, Adjustable Slide Potentiometer Sensor (ASPS), and microcontroller unit (LCD display, connecting wires, Arduino UNO, and power bank... Talib Sabah Hussein,Andrey Izyumov - AIP Conference Proceedings 被引量: 0发表: 2023年 Device for connecting at least two sheathed conduc...