Figure 3-28 Connecting an E-Trunk to a VPLS network Switch Interface VLANIF interface IP Address PE1 GigabitEthernet1/0/1 - - GigabitEthernet1/0/2 - - GigabitEthernet1/0/3 VLANIF 100 10.1.1.1/24 Loopback1 - 1.1.1.9/32 PE2 Gigabit...
Step 1 Connect one end of the yellow Ethernet cable to an Ethernet switch port on the router. (See Figure 3-2.) Figure 3-2 Connecting to an Ethernet Switch 1 Ethernet switch port on the router 3 Yellow CAT5 Ethernet cable, RJ-45–to–RJ-45, connecting to an external Ethernet sw...
Connecting an Ethernet Cable Context The SmartLogger can connect to an Ethernet switch, router, or computer over an Ethernet cable. Procedure Connect an Ethernet cable. Figure 4-11 Connecting an Ethernet cable (1) White and orange (2) Orange (3) White and green (4) Blue (5) White and ...
An Investigation on Standards and Applications of Signalling System No.7 Signaling system 7 (SS7) is the standard communication system that has been used to control public telephone networks since 1980s. Also to control the GSM ... A Affandi¹,M Husain,MAO Batouk 被引量: 0发表: 0年 A ...
Connect an Ethernet cable (supplied by customer)An Ethernet switch that is on your replication networkETH1, Slot63959 SM2server9You need to make these connections only if you are enabling replication. Make sure the replication IP address that is used for port ETH1 is not the same as the rep...
To connect the management port to an Ethernet switch port or hub, insert the RJ-45 connector for a modular, straight-through UTP cable into the management port. To connect to a router, insert the connector on a crossover cable into the managemen...
To connect a copper port to a peer device through an Ethernet twisted pair cable: 1.Plug one end of the cable into the RJ-45 port on the switch. 2.Plug the other end of the cable to the RJ-45 port of the peer device. 3.Verify that the RJ-45 ports are operating correctly by ex...
Gather the necessary equipment: You will need a router, a switch, Ethernet cables, & a power source for each device. Power off all devices: Before making any connections, ensure that both the router & the switch are powered off. Connect the router to the switch: Take an Ethernet cable &...
Optical switch device and optical switching method In an optical switch device, an optical control pulse is inputted into a nonlinear optical fiber in phase with each optical pulse of signal light which is to be outputted, so that the polarization directions of the optical control pulse ... Y...
By default, the switch does not authenticate the console login user at an AUX interface. To increase system security and enable remote management: ·Configure remote access services, for example, Telnet or SSH. ·Configure authentication on each user interface, including the AUX interfaces. ...