待解决 悬赏分:1 - 离问题结束还有 CONNECTED STANDBY Not supported问题补充:匿名 2013-05-23 12:21:38 null 匿名 2013-05-23 12:23:18 连接待机不受支持 匿名 2013-05-23 12:24:58 没支持的连接的待命者 匿名 2013-05-23 12:26:38 不支持的连接待机 匿名 2013-05-23 12:28:18 ...
This behavior occurs because Hyper-V does not support the Connected Standby power state. Laptops that used the AOAC power model and also supported the 64-bit architecture and virtualization features that are required by Hyper‑V were not available when the lat...
I am configuring always on VPN with TND on a Cisco ASA 5508, the client downloads the profile correctly, and correctly recognises when it is on a trusted network, however when we move to an untrusted network I get the error "anyconnect cannot confirm it is connect to ...
If the Check Configuration section fails, look at the log from the "Run ParseTrace.exe" task to determine why it failed. It may be caused by the system not entering in Connected Standby in response to the test issuing that command. ...
The 64 bit support was not there for any platform – Haswell or Bay Trail – and it has been a reason to hold tablets back with the 32 bit version of Windows. In order to support Connected Standby, the entire system needs to be developed with the support in mind, as the following ...
This test verifies that a USB-based device becomes available within 500 milliseconds after the test system exits the S3 or S4 power state or connected standby. The test also confirms that there were not any errant device disconnects during system resume....
When you resume a Windows 8.1-based computer from the Connected Standby power state, all connected or paired input devices do not work. Note This issue frequently occurs after you put the computer into the Connected Standby power ...
These adapters do allow for low power states, however it is not specified on any public documents whether Connected Standby/InstantGo* is supported. It's probable that this information may only be available to developers/OEMs. It's important to note that this specification is supported ...
The system must support Connected Standby. To verify that this sleep state is supported, open a command prompt window, and run the following command: powercfg /a If your system supports Connected Standby, Standby (Connected) will be in the list of available sleep states. Ensure that the ...
Maximum number of VPNs supported by each tenant You can use Info-Finder to query the specifications. For details, see Constraints. Hub site (HQ site) deployment Hub site selection If an enterprise has two HQs, it is recommended that the two HQs function as the active and standby hub site...