For example, I found out that the IP address of the ethernet adapter on my laptop is 169.254.81.78. To create the static IP address for my Pi, I replaced the 78 with 99 to get 169.254.81.99. This is the new static IP address I will use to log in to my Pi via SSH and remote d...
add your user to tty groups, sudo adduser $USER tty remove the lineconsole=serial0,115200from your/boot/cmdline.txtfile. sudo nano /boot/cmdline.txt By default the Raspberry Pi uses this serial port for the console login via the software service “getty”. This will override your settings...
For the record I also tried direct network connection between the Pi and my laptop and also over WiFi. VS2017 finds the device when setting up the debugging. I used Wireshark to see what is going on during the connection attempt. I was filtering on the connection between the Pi and ...
let’s give it a try. Note Raspberry Pi Connect only works with Raspberry Pi OS 64-bit “Bookworm” with Wayland (the Lite version is not supported). I just connected an Ethernet cable and power to my Pi and did not connect any display. After accessing the board through SSH, I install...
An app to allow WiFi configuration to be set via a captive portal. First it checks whether WiFi has been previously configured, if it has it attempts to connect to the configured network, if it hasn't it opens an Access Point to which you can connect using a laptop or mobile phone and...
Does anybody use raspberry pi as Kubernetes node? I kinda have an experience of my pis do not have enough memory with 1Gb. The system would run about 5 minutes, and each second more memory would be allocated. After that, every node shut itself down. Is there anything I can do about th...
I have an additional a work laptop connected to the satellite via WI-FI. I have added the 10gb NIC to the NAS. The main issue is that the NAS will not connect to the internet. Using 1 NIC on the NAS, no matter whether I connect it directly to the Orbi Satellite...
I have a DE2-115 board, and I want to connect two ethernet PHY chip back to back by using Media-Independent Interface (MII) (to work as a simple forwarder). I've been trying to connect MII pinouts with verilog code below, just to find that th...
wlan0 Link encap:Ethernet HWaddr 00:60:64:37:4a:30 inet addr:10.0.0.4 Bcast:10.0.0.255 Mask:255.255.255.0 inet6 addr: fe80::260:64ff:fe37:4a30/64 Scope:Link UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:23868 errors:0 dropped:0 overruns:0 frame:0 ...
USB (Universal Serial Bus) functionality. It refers to the USB controller used in the Raspberry Pi hardware. The DWC2 module is important for enabling USB gadget mode, allowing the Raspberry Pi to act as a USB device, such as an Ethernet adapter, when connected to another computer via USB...