This example uses a Cisco switch as the DHCP server to describe how to configure Option 43 to carry the WAC's IP address of 192.168.100.1. # ip dhcp pool test network 192.168.100.1 255.255.255.0 default-router 192.168.100.1 option 43 hex 030d3139322e3136382e3130302e31 # 03: suboption...
default-router 172.16.29.1 dns-server 172.16.30.2 ! -- dns server (which is not configured on the cmts) domain-name cisco.com lease 7 0 10 ! When configuring the dhcp pools, it is important to include the command cable dhcp-giaddr policy in the cable interface conf...
Please make sure, that server in question has default-gateway and mask assigned on it is correct. FYI... Last, your DHCP server config on the router is missing default gateway address as well but it should not affect the translation on the router. default-router 192.168.1.1 thank...
The host (DHCP client) generates a DHCP request and broadcasts it on the network. When the Cisco NX-OS device receives the DHCP request, it adds the Option 82 information in the packet. The Option 82 information contains the device MAC address (the rem...
Configuring a Cisco 827 Router With a Single IP Address, DHCP, and PPPoAIntroductionBefore You Begin Conventions Prerequisites Components Used Background InformationConfigure Network Diagram ConfigurationVerifyTroubleshootRelated InformationDocument ID
RouterA functions as the DHCP client and dynamically obtains IP addresses of interfaces. Figure 8-2 DHCP client configuration Procedure Configure RouterA. # dhcp enable //Enable the DHCP function. # interface GigabitEthernet0/0/0 ip address dhcp-...
I am quite new and haven't worked before with Cisco router. I have a Cisco 3620 router with only one ethernet interface (FastEthernet 0/0). I want to configure it so that the router will have ip address of 192.168.2.2 (255.255.255.0). I am not using DHCP so all the machines in...
I have an assignment I'm working on for college, one of the tasks is to setup a DNS server, however because I have DHCP setup I cannot add static entries into my DNS. If I create an ARecord and add a host name that matches an IP address, the DHCP might change this IP address al...
I have an assignment I'm working on for college, one of the tasks is to setup a DNS server, however because I have DHCP setup I cannot add static entries into my DNS. If I create an ARecord and add a host name that matches an IP address, the DHCP might change this IP address al...
router ospf 100 network 10.1.1.1 0.0.0.0 area 0 default-information originate ! ip nat inside source static 10.1.2.2 204.15.87.2 ip nat inside source static 10.1.1.3 204.15.87.1 ! ip route 0.0.0.0 0.0.0.0 199.100.35.253 ! The router's E0 interface is designated as being on the inside ...