# Configure a public network interface IP address and a static route. [Router] interface GigabitEthernet 0/0/2 [Router-GigabitEthernet0/0/2] ip address 203.0.113.2 255.255.255.0 //Configure an IP address 203.0.113.2 for GE0/0/2 connected to the public network. [Router-GigabitEthernet0/0/...
# Configure an IP address for the interface connected to the Internet. [Router] interface gigabitethernet 0/0/2 [Router-GigabitEthernet0/0/2] ip address 203.0.113.2 255.255.255.0 //The IP address of the interface connected to the Internet is on the same network segment as the public IP ad...
After working all night and successfully configuring a Cisco router for the TestKing network you save your changes on the startup config, reboot the router, and go out for a cigarette. When you return, none of your changes are active and the router boots to the initial configuration m...
Before we dive into the back end though, you need to password protect your router. Settinga strong, unique passwordfor access to your wireless network is the very first thing you should do when after you plug your router into your modem. Most – if not all – new (not used) routers si...
Network Policy Server Routing and Remote Access Service Routing and Remote Access Service Overview of RRAS Checklists for RRAS Configuring RRAS Configuring RRAS Install RRAS Open the RRAS MMC Snap-in Configure a Dial-Up Remote Access Server Configure the Way RRAS Assigns IP Addresses to VPN Clients...
The firewall is configured for the appropriate rules for site traffic to and from hosts in other sites according to your network security policies. For the Internet interface on the VPN router, configure the following input and output filters using the Routing and Remote Access snap-in. These ...
•RADIUS Tunnel Accounting for L2TP VPDNs •VPDN-Specific Remote RADIUS AAA Server Configurations •Shell-Based Authentication of VPDN Users VPDN Tunnel Authorization Search Order When a call to a network access server (NAS) is to be tunneled to a tunnel server, the NAS must identify...
In general, session control constraints are used for SAGs or SIP proxies outside or at the edge of a network. Enter values for the individual constraints you want applied to the sessions sent to this session agent. The following table lists the available constraints along with a brief ...
A network administrator is configuring ACLs on a cisco router, to allow affic from hosts on networks 192.168.146.0,192.168.147.0,192.168.148.0 and 192.168.149.0 only.Which two ACL statements when combined are the best for accomplishing the task?() ...
Configures a static IP route, where: •prefix—Specifies the IP route prefix for the destination. (This is the IP address of the SGSN.) •mask—Specifies the prefix mask for the destination. (This is the subnet mask of the SGSN network.) •ip-address—Specifies the IP address ...