Router(config-if)# ip ospf hello-interval 1 Router(config-if)# ip ospf 1 area 0 Vs Using (config)#router ospf 1 (config-router)#network 172.16.1.0 0.0.0.255 area 0 I read that the interface command overrides the network command, but both commands would explicitly add the interface.Enterp...
Router(config-if)# ip ospf hello-interval 1 Router(config-if)# ip ospf 1 area 0 Vs Using (config)#router ospf 1 (config-router)#network 172.16.1.0 0.0.0.255 area 0 I read that the interface command overrides the network command, but both commands would explicitly add the interface.Enterp...
To configure a GCC on a controller, complete Configuring GCC Using CTC. Step 2 To configure OSPF on an interface, complete Add OSPF on an Interface Using CTC. Step 3 To configure OSPF-TE, complete Configure OSPF-TE on an Interface Using CTC. Step 4 To configure ...
Configure OSPF Interface Settings Applies To: Windows Server 2003, Windows Server 2003 R2, Windows Server 2003 with SP1, Windows Server 2003 with SP2
interface interface-type interface-number - Enable RIPng on the interface. ripng process-id enable - Configure OSPFv3 Between an MCE Device and a Site Perform the following configurations on the MCE device. Configure OSPFv3 in the site. The site configuration is not...
Configure an OSPF area and enter the OSPF area view. area { area-id | area-id-address } - Enable OSPF on the network segment of the interface to which the VPN instance is bound. network ip-address wildcard-mask - Configure IS-IS Between an MCE Device and a PE...
Current configuration: hostname Router10.1.1.1 ! interface Loopback0 ip address 10.1.1.1255.255.0.0 ! interface Ethernet2/0/0 ip address 10.4.0.1255.255.0.0! interface Serial2/1/0 ip address 10.5.0.1255.255.0.0 ! router ospf 2 network 10.4.0.0 0.0.255.255 area 0 ...
Loopback0 IP addresses of R2 and R3 respectively. More precisely, 10.10.2.2 and 10.10.3.3 are router IDs of R2 and R3 respectively, as an OSPF router chooses the highest IP address on a Loopback interface as its OSPF router ID by default (which influences also the election ofDR and BDR...
Each router interface needs a valid IP address to run. This command matches the given IP address with the IP address of all interfaces. If an interface's IP address matches the given IP address, it enables the OSPF process on that interface and adds that interface to the specified OSPF are...
R2#show ip ospf interface brief Interface PID Area IP Address/Mask Cost State Nbrs F/C Lo0 1 0 10.10.2.2/24 1 LOOP 0/0 Fa0/0 1 0 202.49.12.2/24 1 DR 1/1 MORE READING:Configuring Connection Limits on Cisco ASA Firewalls - Protect from DoS ...