Switch(config-if)# ip address 10.1.1.20 255.0.0.0 Switch(config-if)# exit Switch(config)# line vty 0 4 Switch(config-line )# login authentication myauth On the packet tracer, you need to add a generic server to the switch and set the IP to 10.1.1.10. Next click on the server icon...
Packet-tracer is an inbuilt utility on the Nexus 9000 that can be used to trace the path of the packet through the switch. It can be invoked using the command line and can be configured to match IP address and or layer 4 attributes. It cannot be used to match ARP traffic. T...
Correct me if I'm wrong, the way I interpret the "address prefix h:h:.../i" command is ...
Correct me if I'm wrong, the way I interpret the "address prefix h:h:.../i" command is ...
This is normal, because you’ve already configured an IP address on this vlan 100 and, as I said, it would be active as soon as the VLAN is created, which is what you’ve just done! Okay, I’ll go through it in a video, too: Now that you can do it on your...
R2(config-if)#ip address 10.0.0.2 255.255.255.252 R2(config-if)#no shutdown Since the DCE end of the cable is connected to the second router a clock rate has to be set. Also note that the following Hostname of first router = Username of the second router ...
Op een switch, nadat het host B MAC-adres is aangeleerd, wordt unicastverkeer van A naar B alleen doorgestuurd naar de B-poort. Daarom ziet sniffer dit verkeer niet: In deze configuratie neemt de snuifschakelaar alleen verkeer op dat naar alle poorten is overstroomd, zoals: ...
If you have a Packet Tracer project file, post the (zipped) file here... 5 Helpful Reply Seb Rupik VIP Alumni 10-19-2021 05:45 AM Hi there, The built-in ports on a 2911 are routed switchports, this means they must be configured with an IP address belonging to a unique...
The following image shows the above configuration on the packet tracer.Router2 IP configurationRouter>enable Router#configure terminal Router(config)#interface fastethernet 0/0 Router(config-if)#ip address 30.0.0.1 255.0.0.0 Router(config-if)#no shutdown Router(config-if)#exit Router(config)#...
You can configure IP address under Vlan1. Switch(config)# interface vlan 1 Switch(config)# ip address 192.168.1.1 255.255.255.0 Switch(config)# no shut Now since you don’t have any other vlans, when you connect a PC to any port of the switch you can telnet to it. Also, don’t ...