When users perform VPN authentication with a Cisco ASA with the AnyConnect VPN Client software, in some instances it is useful to assign the same static IP address to a client. Here, you can configure a static IP address per user account in AD and use this IP addres...
Configure my laptop's LAN interface with the IP address of the default gateway that the AP will have Power on the Power Injector and wait for the AP to boot up Configure the AP's hostname using the command: capwap ap hostname <Access Point Hostname> Configure the static IP...
interface GigabitEthernet0/0/0/1 !! Link between CE2-PE2 ipv4 address 30.1.1.2 255.255.255.0 ipv6 address 30::2/64 ! router static address-family ipv4 unicast 20.1.1.0/24 30.1.1.1 address-family ipv6 unicast 20::0/64 30::1 ! !
Address assignment The DHCP server determines the scope to which a DHCP client belongs based on the gateway IP address of the relay agent or the interface of the DHCP server on which it receives the DHCP client packet. Once the server determines the client scope, the server evaluates the DHCP...
ip address 10.1.2.3 255.255.255.0 ! interface GigabitEthernet0/0.200 encapsulation dot1q 200 ip address 10.2.3.4 255.255.255.0 ! You simply create subinterfaces on the physical interface, associate them with a VLAN, and that's it. In my example, I've used the VLAN ID as the subinterface ...
interface ge0/2 descriptionDESCRIPTION-1 ip address192.168.1.1/24 (EXAMPLE) tcp-mss-adjust 1300 no shutdown dhcp-server address-pool192.168.1.0/24 (EXAMPLE) offer-time 600 lease-time 86400 admin-state up options default-gateway192.168.1.1 (EXAMPLE) ...
use the IP address of serial 0/0 interface or can use the IP address of serial 0/1 interface or can use the IP address of loopback interface. The only benefit of using loopback interface’s IP address over physical interface’s IP address is that loopback interface remains always on. ...
Interface Name Name of protected Cisco interface. Outside Server IP For on-premise version: IP of server where IDP(miniOrange) is installed For cloud version: Use the Radius Server IPs which you got from Step1. Timeout Authentication timeout. 60 Server Authentication Port RADIUS authentication po...
Switch to the loopback 0 interface view and configure the tunnel IP address. Example: interface loopback 0 ip address 2.2.2.2 255.255.255.255 Use the quit command to exit the interface view and return to the system view. Switch to the bridge domain (BD) view and configure the VXLAN VNI...
SW1(config-if-range)# no ip address SW1(config-if-range)# channel-group 1 mode desirable SW1(config-if-range)# end [bodyads] Switch-2 Configuration: SW2# configure terminal SW2(config)# interface port-channel 1 SW2(config-if)# no switchport SW2(config-if)# ip address 192.168.1.2 255...